Isuzu Trooper (2000 year). Manual — part 420
MANUAL TRANSMISSION
7B–9
225RX001
5. Apply a force of about 113 N (26 lb) to the tip of the
shift fork in the direction of the transmission to engage
the clutch pressure plate and release bearing.
NOTE: A clicking sound is heard when the release
bearing and the tip of the diaphragm spring engage each
other.
Check to see if they are securely engaged by pushing the
tip of the shift fork toward the engine while applying a
force of about 25 N (5.5 lb). If the shift fork will not move,
then they are securely engaged.
220RS006
6. Install three flywheel under cover.
7B–10 MANUAL TRANSMISSION
7. Install the engine rear mount to the transmission case
and tighten the fixing bolts specified torque.
Torque: 41 N·m (30 lb ft)
8. Install the harness heat protector.
9. Install the right front exhaust pipes and catalytic
converter assembly.
Torque
Exh. pipe to exh. manifold: 67 N·m (49 lb ft)
Exh. pipe flange bolt: 43 N·m (32 lb ft)
10. Connect four oxygen sensor connectors to the
transmission harness.
11. Install the third crossmember to the frame and tighten
the fixing bolts specified torque.
Torque: 50 N·m (37 lb ft)
12. Tighten the engine rear mount nuts specified torque.
Torque: 50 N·m (37 lb ft)
13. Remove the transmission jack.
14. Apply the grease to top hole portion of the shift fork.
15. Install the slave cylinder and tighten the fixing bolts
specified torque.
Torque: 43 N·m (32 lb ft)
Install the clutch dust cover to the clutch housing and
tighten the fixing bolts specified torque.
Torque: 8 N·m (69 lb in)
220RS007
16. Install the slave cylinder heat protector to the slave
cylinder.
17. Install harness heat protector.
225RW006
18. Install four fuel pipe bracket.
MANUAL TRANSMISSION
7B–11
141RW024
19. Install bracket and two transmission harness clamps
to the transmission case.
220RS028
20. Connect the speedometer sensor and 2WD–4WD
actuator harness connector.
225RW007
7B–12 MANUAL TRANSMISSION
21. Connect the backup lamp switch, 4WD indicator
switch, and 1-2 indicator switch harness connectors.
230RW005
22. Install the front propeller shaft and tighten the fixing
bolts and nuts specified torque.
Torque: 63 N·m (46 lb ft)
23. Install the rear propeller shaft and tighten the fixing
bolts and nuts specified torque.
Torque: 63 N·m (46 lb ft)
24. Install transfer protector and tighten the fixing bolts
specified torque.
Torque: 37 N·m (27 lb ft)
25. Install the transmission control lever and transfer
control lever.
26. Install the grommet assembly.
27. Install the front console assembly.
28. Install the gear control lever knob.
235RX001
29. Connect battery ground cable.
30. Install engine hood.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст