Isuzu Trooper (2000 year). Manual — part 508
8J–12
EXTERIOR/INTERIOR TRIM
2. Pass the inside handle through the mounting hole of
the trim panel. Assemble the trim panel. Engage
securely seven clips into the door panel. Also,
connect the courtesy light connector. Leave the
connector of the power window drawn out to its
prescribed position, so that it will not caught.
3. Put back the inside handle(3) to the original position
of the link(5). Fit the claw(4) of the inside handle
securely into the hole of the door panel. Fix the
handle with the screw.
632RW011
EXTERIOR/INTERIOR TRIM
8J–13
Door Wood Panel Assembly
Door Wood Panel Assembly and Associated Parts
635RS010
Legend
(1) Door Trim Panel
(2) Door Wood Panel Assembly
Removal
1. Remove the door trim panel(1).
D
Refer to the Front / Rear Door Trim Panel in this
section.
2. Remove the door wood panel assembly(2).
D
Remove four door wood panel assembly fixing
screws and washers.
NOTE: The removal and installation steps are common
to both front and rear doors.
635RS009
Installation
To install, follow the removal steps in the reverse order.
8J–14
EXTERIOR/INTERIOR TRIM
Door Mirror
Door Mirror and Associated Parts
720RS012
Legend
(1) Door Mirror Cover / Tweeter
(2) Door Mirror Connector
(3) Door Mirror
Removal
1. Disconnect the battery ground cable.
2. Remove the door mirror cover(1).
D
Remove the connectors(2) and the door mirror
cover, if equipped with a tweeter.
720RS007
3. Remove the door mirror connector.
4. Remove the door mirror.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. When you install the door mirror, install the bolt(1) to
the mirror temporarily, hook the bolt to the door side
hole and tighten the bolt from the inside.
720RS001
2. When installing the door mirror, hold the glass run
lip(2) between the door mirror base(3) and the center
sash(4).
A10RS001
3. Tighten the door mirror fixing bolts to the specified
torque.
Torque: 8 N·m (69 lb in)
EXTERIOR/INTERIOR TRIM
8J–15
Luggage Side and Quarter Upper Trim Cover
Luggage Side, Quarter Upper Trim Cover and Associated Parts
687RS001
Legend
(1) Quarter Upper Trim Cover
(2) Rear Seat Belt Anchor Bolt Cover and Anchor
Bolt
(3) Roof Side Trim Cover
(4) Luggage Side Lower Cover
(5) Luggage Side Trim Cover
(6) Rear End Floor Trim Cover
(7) Luggage Side Cap
(8) Speaker Grille
(9) Rear Speaker
(10) Clip
(11) Luggage Room Light
(12) Rear Roof Trim Cover
Removal
1. Disconnect the battery ground cable.
2. Remove the rear end floor trim cover.
3. Remove the luggage side cap.
4. Remove the luggage side lower cover.
5. Remove the luggage side trim cover (1).
D
Remove the rear side fixing screws and pry the trim
cover retainers free from the body panel and the
upper trim cover.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст