Isuzu Trooper (2000 year). Manual — part 85
4A2–22 DIFFERENTIAL (REAR)
4. Adjust feeler gauge thickness from side to side
until ring gear backlash is in the specified range.
Backlash: 0.13– 0.2mm (0.005– 0.008in)
425RS032
With zero end play and correct backlash
established, remove the feeler gauge packs,
determine the thickness of the shims required and
add 0.05 mm (0.002 in) to each shim pack to
provide side bearing preload. Always use new
shims.
5. Remove side bearing by using remover J–42379
and adapter J–8107–3.
415RW003
12. Install the side bearings together with the selected
shims by using installer J–42829 (2) and grip J–8092
(1).
425RW032
13. Install side bearing outer race.
14. Install differential cage assembly.
15. Align the setting marks (1) applied at disassembly
then install the bearing cap.
425RS035
DIFFERENTIAL (REAR)
4A2–23
16. Tighten the bolt to the specified torque.
Torque:108N·m (80lb ft)
425RS036
Gear Tooth Contact Pattern Check and Adjustment
1. Apply a thin coat of Prussian blue or equivalent to the
faces of the 7–8 teeth of the ring gear. Check the
impression of contact on the ring gear teeth and make
necessary adjustment as described in illustration if
the contact is abnormal.
425RS038
Legend
(1) Heel
(2) Toe
(3) Concave Side(Coast)
(4) Convex Side(Drive)
425RS039
4A2–24 DIFFERENTIAL (REAR)
Differential Cage Assembly
Disassembled View
415RY00001
Legend
(1) Pinion Mate Gear
(2) Thrust Washer(for Side Gear)
(3) Side Gear
(4) Differential Shaft
(5) Ring Gear
(6) Bolt
(7) Differention Cage
(8) Lock Pin
DIFFERENTIAL (REAR)
4A2–25
Disassembly
1. Remove bolt.
2. Remove ring gear.
3. Remove lock pin using a small drift.
425RY00002
4. Remove the differential shaft by using a hard metal
rod and a hammer.
425RS043
5. Remove pinion mate gear and thrust washer.
6. Remove side gear and thrust washer.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D
Ring gear, pinion gear
D
Bearing
D
Side gear, pinion mate gear, differential shaft
D
Differential cage, carrier
D
Thrust washer
D
Oil seal
Ring gear replacement:
1. The ring gear should always be replaced with the
drive pinion as a set.
2. Clean the ring gear threaded holes to remove the
locking agent.
3. Discard used bolts and install new ones.
4. When installing the ring gear, apply LOCTITE 271 or
equivalent to all the threaded area and half of the
unthreaded area of the bolt.
Torque: 127N·m (94 lb ft)
425RW033
Clearance between the differential pinion and the
pinion shaft measurement.
Standard: 0.07 – 0.13 mm (0.003 – 0.005 in)
Limit: 0.2 mm (0.008 in)
425RY00007
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст