Isuzu Trooper (2000 year). Manual — part 477
8F–55
BODY STRUCTURE
Rear Window Regulator And Glass
Parts Location
651RW012
Legend
(1) Window Regulator
(2) Glass
(3) Cable Fixing Clip
(4) Window Regulator Motor Connector
(5) Door Trim Panel
(6) Waterproof Sheet
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
D
Refer to Rear Door Trim Panel in Exterior / Interior
Trim section.
3. Remove waterproof sheet (1).
D
Taking notice of the door harness, peel the
waterproof sheet off the door panel carefully.
651RS002
8F–56
BODY STRUCTURE
4. Remove glass.
D
Bring the glass down to the position where the bolt
can be seen.
D
Remove the sash division 2 fixing bolts (1) and then
remove the glass fixing bolt to remove the glass
upwards.
651RS003
651RW010
5. Remove window regulator.
D
Disconnect the regulator motor connector (4) and
remove the window regulator cable fixing clip (3)
from the door panel, if model is equipped with power
windows.
D
Remove the window regulator 7 fixing bolts (2) and
pull the regulator out from the lower hole of the door
panel.
651RW011
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the window regulator and the glass fixing
bolts to the specified torque.
Torque : 8 N
•
m (69 lb in)
2. Install the waterproof sheet with no clearance
between the door panel and the waterproof sheet.
8F–57
BODY STRUCTURE
Rear Door Fixed Glass And Glass Run
Parts Location
651RS006
Legend
(1) Glass Run
(2) Rear Fixed Glass
(3) Sash Division
(4) Sash Division Fixing Bolts
(5) Door Trim Panel
(6) Waterproof Sheet
(7) Glass
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
3. Remove waterproof sheet.
4. Remove glass.
D
Refer to Rear Window Regulator and Glass in this
section.
5. Remove glass run.
D
Pull the glass run (1) out from the door frame.
651RS007
8F–58
BODY STRUCTURE
6. Remove sash division (2).
651RS008
7. Remove door fixed glass.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Apply soap and water to the fixed glass.
2. Apply soap and water to the door groove and insert
the glass run (3) to the frame from the corner in the
arrow-marked directions.
3. Be sure to install the glass run with its end pointed to
the inside of the vehicle.
A10RW019
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст