Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1346
8–304 ELECTRICAL-BODY AND CHASSIS
TROUBLE SHOOTING
CIGARETTE LIGHTER
1.
Lighter does not pop out after being pushed in. It does not become hot.
Checkpoint
Trouble Cause
Countermeasure
Poor Fuse No. CB-20 (15A,
Fuse box) contact or blown
Reinstall or replace the fuse
No. CB-20 (15A)
Audio system (System
should receive power)
Open circuit or poor
connector contact
Replace the lighter
Lighter continuity between
center part and outer area
Open circuit or poor
connector contact
Repair open circuit or
connector contact
Voltage between connector
1 B-21 and the ground at
starter SW. is ACC position
(Should be battery voltage
present)
OK
OK
OK
NG
NG
NG
2.
Lighter pops out prematurely before becoming hot
Deformed lighter or casing
Repair or replace the lighter
and/or casing
Lighter and casing
NG
3.
Lighter becomes too hot
Deformed lighter and
casing
Repair or replace the lighter
and/or casing
Lighter and casing
NG
Open circuit or poor
connector contact
Repair open circuit or
connector contact
Continuity between
connector 1 B-22 and the
ground
NG
ELECTRICAL-BODY AND CHASSIS 8–305
CIGARETTE LIGHTER
Removal
1. Remove the lighter 1.
2. Disconnect the connector 2.
3. Loosen the lighter holder 3 nut at the back side.
4. Remove the holder from the bezel.
AUDIO
Refer to Section 9 “ACCESSORIES” for details.
1
2
3
D08RV882
Installation
Follow the removal procedure in the reverse order to
install the lighter.
Pay close attention to the important points mentioned in
the following paragraphs.
Connector
Be absolutely sure that the lighter connector is securely
connected.
This will prevent a poor contact and an open circuit.
REMOVAL AND INSTALLATION
8–306 ELECTRICAL-BODY AND CHASSIS
POWER DOOR MIRROR
PARTS LOCATION (LHD)
H-10
H-13
B-26
D-7
H-7
D-2
C-41
B-28
D08RVA51
ELECTRICAL-BODY AND CHASSIS 8–307
PARTS LOCATION (RHD)
C-41
D-7
H-13
H-10
B-28
B-26
D-2
H-7
D08RVA49
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст