Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 875
6E–229
3.2L ENGINE DRIVEABILITY AND EMISSIONS
Installation Procedure
1. Install the IAC valve on the throttle body with the bolts.
Tighten
D
Tighten the bolts to 1 N·m (0.1 kg·m/9 lb in.).
060RW063
2. Connect the IAC valve electrical connector.
3. Install the negative battery cable.
Common Chamber
Removal and Installation Prodedure
Refer to Common Chamber in Engine Mechanical.
Accelerator Cable Assembly
Removal Procedure
1. Loosen the nut on the cable bracket mounting on the
common chamber.
101RW005
2. Remove the accelerator control cable (on the throttle
valve end).
101RW006
3. Remove the accelerator control cable (on the
accelerator pedal end).
TS23982
4. Remove the grommet.
6E–230 3.2L ENGINE DRIVEABILITY AND EMISSIONS
5. Remove the accelerator control cable.
TS23983
Inspection Procedure
Check the following items, and replace the control cable if
any abnormality is found:
D
The control cable should move smoothly.
D
The control cable should not be bent or kinked.
D
The control cable should be free of damage and
corrosion.
Installation Procedure
1. Install the accelerator control cable.
TS23983
2. Install the grommet.
3. Install the accelerator control cable (on the
accelerator pedal end).
TS23982
4. Install the accelerator control cable (on the throttle
valve end).
101RW006
6E–231
3.2L ENGINE DRIVEABILITY AND EMISSIONS
5. Install the nut.
101RW007
Accelerator Pedal Replacement
Removal Procedure
1. Disconnect the cruise control cable from the
accelerator pedal assembly.
TS24053
2. Disconnect the accelerator pedal control cable from
the accelerator pedal assembly.
TS24054
3. Disconnect the wiring harness from the kick-down
switch.
TS24038
6E–232 3.2L ENGINE DRIVEABILITY AND EMISSIONS
4. Remove the two screws from the accelerator pedal
assembly.
TS24055
5. Remove the accelerator pedal assembly from the
bulkhead.
Installation Procedure
1. Install the accelerator pedal assembly on the
bulkhead.
2. Install the two screws to the accelerator pedal
assembly.
TS24055
3. Connect the wiring harness to the kick-down switch.
TS24038
4. Connect the accelerator pedal control cable to the
accelerator pedal assembly.
TS24054
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст