Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 385
7A-88 AUTOMATIC TRANSMISSION (AW30-40LE)
Engine – Transmission Bolt Torque
225R200005
AUTOMATIC TRANSMISSION (AW30-40LE) 7A-89
Transmission-Transfer Case Bolt Torque (Reference)
260RY00001
7A-90 AUTOMATIC TRANSMISSION (AW30-40LE)
UNIT REPAIR
MAJOR COMPONENTS
Disassembly, inspection and reassembly of each
component group is indicated in the following chapter.
Before reassembly, make sure, again, that all component
groups are assembled correctly.
If something wrong is found in a certain component group
during assembly, inspect and repair this group
immediately.
GENERAL ASSEMBLY NOTES:
1. The automatic transmission is composed of highly
precision-finished parts, necessitating careful inspection
before assembly because even a small nick could cause
fluid leakage or affect performance.
2. Before assembling new clutch discs and brake bands,
soak them in automatic transmission fluid for at least thirty
minutes.
3. Apply automatic transmission fluid on the sliding or rotating
surfaces of parts before assembly.
4. Use petroleum jelly to keep small parts in their palces.
5. Do not use adhesive cements on gaskets and similar
parts.
6. When assembling the transmission, be sure to use new
gaskets and O-rings.
7. Dry all parts with compressed air – never use shop rags.
8. Be sure to install the thrust bearings and races in the
correct direction and position.
AUTOMATIC TRANSMISSION (AW30-40LE) 7A-91
240RY00022
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст