Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 418
7A-220 AUTOMATIC TRANSMISSION (AW30-40LE)
243R200037
29. Retainer
Install the retainer by pushing in the plug.
243R200038
30. Throttle valve
Inset the throttle valve into the bore.
NOTE:
Check that the valve is fully inserted into the bore.
243R200039
31. Valve stopper
Install the valve stopper as shown.
243R200040
32. Adjusting ring
Turn over valve body, and install the same number of
adjusting rings as were removed during disassembly.
243R200041
33. Spring
Install the spring onto the end of the valve shaft.
AUTOMATIC TRANSMISSION (AW30-40LE) 7A-221
243R200042
34. Spring
35. Down-shift plug
Install the spring and down-shift plug into the bore.
243R200043
36. Pin
Install the pin by pushing in the plug.
243R200044
37. Sleeve
Insert the sleeve through one side of the cam.
243R200045
38. Spring
Install the spring with the hook through the hole in the
cam.
243R200046
39. Throttle cam assembly
Check that position of the spring end is positioned as
shown in the figure.
Tighten bolt.
Torque: 10 N・・・・m (1.0 kg・・・・m/87 Ib・・・・in)
7A-222 AUTOMATIC TRANSMISSION (AW30-40LE)
243R200006
NOTE:
Make sure pin, seven retainers and valve stopper are
installed correctly
40. Check ball
Install the two types of check balls (total 9 pcs.) to the
valve body.
Check
ball
Diameter
(A) Rubber ball
6.35 mm (0.2500 in)
(B) Rubber ball
5.56 mm (0.2189 in)
243R200050
243R200048
41. Strainer
Install strainer.
AUTOMATIC TRANSMISSION (AW30-40LE) 7A-223
TRANSMISSION CASE
DISASSEMBLY
249RY00001
Disassembly steps
1. Spacer
2. Pin
3. Manual valve lever shaft
4. Manual
valve
lever
5. Oil
seal
6. Oil
seal
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст