Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1100
ELECTRICAL-BODY AND CHASSIS 8-157
2. One side of horn does not blow
Checkpoint
Trouble Cause
Countermeasure
Repair open circuit or
reconnect the connector
Open circuit or poor connector
contact
NG
Voltage between 1
C-20
(1
C-21
) - ground with
horn switch depressed
(Should be battery voltage
present)
Replace the horn assembly
Horn continuity between
connectors
Faulty horn assembly
NG
OK
3. Insufficient horn volume
Clfean and/or remove the
foreign material
Stain foreign material in the
horn
NG
Horn
Recharge or replace the
battery
Battery condition
Discharged battery
NG
OK
8-158 ELECTRICAL-BODY AND CHASSIS
REMOVAL AND INSTALLATION
REAR COMBINATION LIGHT
Stoplight
Removal
1. Open the rear gate.
2. Remove the screws of rear combination light.
3. Remove the rear combination light assembly.
4. Turn the bulb
2
counterclockwise to remove it.
Installation
Follow the removal procedure in the reverse order to install the
rear combination light.
Pay close attention to the important points mentioned in the
following paragraphs.
Bulb
Be absolutely sure that each bulb is correctly installed.
This will prevent a poor contact and an open circuit.
ELECTRICAL-BODY AND CHASSIS 8-159
FRONT TURN LIGHT
Removal
1. Remove the screws of the front turn light.
2. Pull out the light housing for front turn light from bumper.
3. Push the bulb in and turn it counterclockwise to remove it
from the light housing.
Installation
Follow the removal procedure in the reverse order to install the
front turn light.
Pay close attention to the important points mentioned in the
following paragraphs.
Bulb
Be absolutely sure that the front turn light bulb is correctly
installed.
This will prevent a poor contact and an open circuit.
8-160 ELECTRICAL-BODY AND CHASSIS
SIDE TURN LIGHT
Removal
1. Remove the lens
1
.
• Pull the light/bulb toward you while pushing the light
housing in the rear direction of the vehicle to release its
lock.
• Remove the socket by turning it counterclockwise.
2. Pull the bulb
2
to remove it.
Installation
Follow the removal procedure in the reverse order to install the
side turn light.
Pay close attention to the important points mentioned in the
following paragraphs.
Bulb
Be absolutely sure that the side turn light bulb is correctly
installed.
This will prevent a poor contact and an open circuit.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст