Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1604
2B-2 SHEET METAL
Important Operations - Removal
1. Bolt
Before removing the hinges from the engine hood, scribe a
mark showing location of the hinges to facilitate installation in
the original position.
4. Radiator Grille
Remove the radiator grille center screw
1
.
(ONE POINT)
Use a screwdriver to raise the clip
2
and release the lock.
Place a clean rag beneath the screwdriver tip to protect the
body painted surfaces. (EIGHT POINTS)
Remove the radiator grille
3
.
6. Combination Lamp
Remove the combination lamp fixing screws.
Turn the socket
1
counterclockwise to disconnect it from the
marker light housing.
Pull the bulb from the socket.
SHEET METAL 2B-3
7. Inner Liner
Remove the inner liner fixing screws.
11. Fender
First, remove the bolt (See illustration arrow mark) from the
inside of the car.
2B-4 SHEET METAL
ADJUSTMENT
A. Check the Engine Hood and Fender
mm (in.)
Clearance (a)
4 (0.157)
Height (b)
Flush
Adjust the clearance (a) with the hinges on the engine hood.
Adjust the step (b) with the hood rests.
B. Check the Fender and Door
C. Check the Door and Body
D. Check the Front Door and Rear Door
mm (in.)
Clearance (a)
5.5 (0.217)
Height (b)
Flush
Adjust clearance (a) with door hinges.
Adjust the step (b) by tapping on the fender lightly with a rubber
hammer.
TFFAB-WE-981
You are requested to order this manual using the
manual number that is shown above.
This manual is applicable for vehicles in all countries
except the USA, Canada, Europe and Thailand.
All rights reserved, This manual may not be
reproduced in whole or in part, without the permission
in writing of ISUZU MOTORS LIMITED.
Issued by
ISUZU MOTORS LIMITED
INTERNATIONAL SERVICE DEPARTMENT
Tokyo, Japan
First edition May., 1998
9805-01A-4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст