Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1398
ELECTRICAL-BODY AND CHASSIS 8-157
TEMPERATURE GAUGE AND THERMO
UNIT
Temperature Gauge On-Vehicle Inspection
1. Disconnect the temperature gauge wire connector.
2. Connect a 3.4 Watt test bulb
1
to the ground.
The gauge needle should move the middle part of the
gauge
Temperature Gauge Off-Vehicle Inspection
Use a circuit tester to measure the temperature gauge
resistance.
Temperature Gauge Resistance
Ω
Standard
Measuring Point
With
Tachometer
Without
Tachometer
IGN (+) - Ground
130
-
IGN (+) - UNIT
82
-
UNIT - Ground
212
-
VOLTAGE
REGULATOR - UNIT
-
25
8-158 ELECTRICAL-BODY AND CHASSIS
Thermo Unit Inspection
The thermo unit is thermistor type and must be inspected
under the conditions as shown in the left chart.
1. Put the deviation of the galvanometer to 0 by using the
variable resistor, switch the thermo unit off and then
measure the resistance of the resistor through the bridge.
Confirm that the resistance is continuously variable in any
other points than those shown in the following table.
2. Dip the thermo unit into 80 - 90
°C (176 - 194°F) water and
confirm that there is no bubble continuously coming out of
inside of the unit.
Replace the unit when the result of inspection is found
abnormal.
Temperature
Check
condition
50
°C
(122
°F)
115
°C
(239
°F)
7V 55
Ω
Gauge
Resistance
+33.6
226.0
-36.6
+1.71
26.4
-2.21
7V 25
Ω
Gauge
value (
Ω)
-
+2.68
24.3
-3.68
ELECTRICAL-BODY AND CHASSIS 8-159
FUEL GAUGE AND TANK UNIT
Fuel gauge On-Vehicle Inspection
1. Disconnect the fuel gauge wire connector.
2. Connect a 3.4 Watt test bulb
1
to the ground.
The gauge needle should more the middle part of the
gauge.
Fuel Gauge Off-Vehicle Inspection
Use a circuit tester to measure the fuel gauge resistance.
Fuel Gauge Resistance
Ω
Standard
Measuring Point
With
Tachometer
Without
Tachometer
IGN (+) - Ground
223
110
IGN (+) - 7V
(0)
IGN (+) - UNIT
83
25
Ground - 7V
110
Ground - UNIT
140
135
7V - UNIT
25
8-160 ELECTRICAL-BODY AND CHASSIS
Fuel Tank Unit Inspection
Measure the fuel tank unit resistance between the connector
terminals 1
F-1
and 3
F-1
while shifting the float from “E”
to “F” point.
Fuel Tank Resistance
Level
Float position
mm
Standard resistance
Ω
F (B)
51.7
17
± 2.1
1/2 (A)
49.4
45
± 4.5
E (C)
166.9
120
± 6.5
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст