Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1794
UNIT REPAIR (JR405E) 7A4-43
06C&L-SUB08
07C&L-SUB09
08C&L-SUB10
09C&L-SUB11
10C&L-SUB12
•
Remove the bearing race from the rear internal gear.
7A4-44 UNIT REPAIR (JR405E)
11C&L-SUB13
11.Snap ring
Remove the low clutch snap ring.
12C&L-SUB15
12.Retaining plate, drive plate, driven plate, and dish plate
Remove the low clutch retaining plate, the 7 drive plates,
the 7 driven plates, and the dish plate.
13C&L-SUB18
13.Snap ring
•
Install the spring compressor to the low clutch drum.
Spring compressor: 5-8840-2759-0
•
Carefully press the cancel cover down.
Take care not to damage the return spring.
14C&L-SUB19
•
Remove the snap ring.
31C&L-SUB20
14.Cancel cover
Remove the cancel cover.
UNIT REPAIR (JR405E) 7A4-45
30C&L-SUB21
15.Return spring
Remove the return spring.
15C&L-SUB38
16.Low clutch piston
•
Insert the low one-way clutch inner race to the low
clutch drum.
•
Force compressed air through the oil passages of the
low one-way clutch inner race to remove the low clutch
piston.
29C&L-SUB22
16C&L-SUB25
17.Snap ring
•
Raise the low one-way clutch side.
•
Remove the low one-way clutch snap ring.
17C&L-SUB27
18.Side plate
Remove the side plate.
7A4-46 UNIT REPAIR (JR405E)
18C&L-SUB28
19.Low one-way clutch
Remove the low one-way clutch.
19C&L-SUB29
20.Snap ring
Remove the snap ring from the low clutch drum.
20C&L-SUB31
21.Bearing
Remove the bearing.
Inspection
Drive plate
•
Measure the drive plate facing thickness at 3 points.
•
Calculate the average value.
If the average value is less than the specified limit, the
drive plate must be replaced.
Drive plate facing thickness:
Standard – 2.0 mm (0.079 in)
Limit – 1.8 mm (0.071 in)
Return spring
•
Check the number of effective return spring coils.
If the number is less than the specified minimum, the
return spring must be replaced.
Effective return spring coils (standard): 9.9
•
Measure the return spring outside diameter, free length,
and linear diameter.
If any of the measured values exceed the specified limit,
the return spring must be replaced.
Return spring measurements (standard):
Outside diameter – 9.7 mm (0.382 in)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст