Isuzu Rodeo UE. Manual — part 57
4A1–19
DIFFERENTIAL (FRONT)
Differential Cage Assembly
Disassembled View
415RW010
Legend
(1) Thrust Washer
(2) Pinion Gear
(3) Thrust Washer
(4) Side Gear
(5) Cross Pin
(6) Ring Gear
(7) Bolt
(8) Differential Cage
(9) Lock Pin
Disassembly
1. Remove bolt.
2. Remove ring gear.
3. Remove lock pin.
425RS042
DIFFERENTIAL (FRONT)
4A1–20
4. Remove the cross pin, using a soft metal rod and a
hammer.
425RS043
5. Remove pinion gear and thrust washer.
6. Remove side gear.
7. Remove thrust washer.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts.
1. Ring gear, pinion gear
2. Bearing
3. Side gear, pinion gear, cross pin
4. Differential cage, carrier
5. Thrust washer
6. Oil seal
Ring gear replacement:
1. The ring gear should always be replaced with the
drive pinion as a set.
2. Discard used bolts and install new ones.
Torque: 108 N·m (80 lb ft)
3. Tighten the fixing bolts in a diagonal sequence as
illustrated.
415RS016
Reassembly
1. Install thrust washer.
2. Install side gear.
3. Install the pinion gear with thrust washer by engaging
it with the side gears while turning both pinion gears
simultaneously in the same direction.
425RS048
4A1–21
DIFFERENTIAL (FRONT)
4. Install cross pin.
f
Be sure to install the cross pin so that it is in
alignment with the lock pin hole in the differential
cage.
425RS049
5. Install lock pin. After lock pin installation, stake the
cage to secure the lock pin.
6. Install ring gear and tighten the bolts in diagonal
sequence as illustrated.
Torque: 108 N·m (80 lb ft)
NOTE: Discard used bolts and install new ones.
415RS016
DIFFERENTIAL (FRONT)
4A1–22
Main Data and Specifications
General Specifications
Axle tube Type
It consists of the duct, a cast iron housing and the axle
tube.
Gear type
Hypoid
Gear ratio
(to 1)
3.727 (6VD1 with A/T)
4.100 (6VD1 with A/T, 6VD1 with M/T)
4.300 (6VD1 with M/T)
4.555 (X22SE with M/T)
4.777 (X22SE with M/T)
Differential type
Two pinion
Oil capacity
liter (US qt)
1.25 (1.32) (Differential)
0.12 (0.13) (Actuator Housing: Shift on the fly)
Type of lubricant
GL–5 (75W–90)
Axle shaft type
Constant velocity joint (Birfield joint type and double off-
set joint)
Hub locking Type
Rigid
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст