Isuzu Rodeo UE. Manual — part 295
6A–93
ENGINE MECHANICAL (6VD1 3.2L)
Engine mount
E06RW028
6A–94
ENGINE MECHANICAL (6VD1 3.2L)
Special Tool
ILLUSTRATION
TOOL NO.
TOOL NAME
J–21687–02
Remover; tie rod end
J–36390
Wrench; Oil filter
J–8062
Compressor; Valve
spring (1)
J–42898
Adapter; Compressor,
Valve spring (2)
J–37281
Remover; Oil controller
J–38537
Installer; Oil controller
J–29107
Universal pitman arm
puller
ILLUSTRATION
TOOL NO.
TOOL NAME
J–42985
Installer; Camshaft oil
seal
J–39206
Installer; Pilot bearing
J–8614–01
Holder; Crankshaft
J–37228
Seal cutter
J–39201
Installer; Real oil seal
J–39202
Installer; Oil pump oil
seal
6A–95
ENGINE MECHANICAL (6VD1 3.2L)
ILLUSTRATION
TOOL NO.
TOOL NAME
J–24239–1
Cylinder head bolt
wrench
J–42899
Replacer; Valve guide
(1,2)
J–42687
Installer; Valve guide (1)
J–37985–1
Remover; Valve guide
(2)
J–42689
Adjusting Tool; Valve
clearance
J–42686
Lever; Gear spring
J–43041
Holder; Universal
ENGINE COOLING (6VD1 3.2L)
6B–1
RODEO
ENGINE
ENGINE COOLING (6VD1 3.2L)
CONTENTS
Service Precaution
6B–1
. . . . . . . . . . . . . . . . . . . . . .
General Description
6B–2
. . . . . . . . . . . . . . . . . . . . .
Diagnosis
6B–4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Draining and Refilling Cooling System
6B–5
. . . . .
Water Pump
6B–6
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Water Pump and Associated Parts
6B–6
. . . . . . .
Removal
6B–6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection
6B–6
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation
6B–6
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Thermostat
6B–7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Thermostat and Associated Parts
6B–7
. . . . . . . .
Removal
6B–7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection
6B–7
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation
6B–7
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Radiator
6B–8
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Radiator and Associated Parts
6B–8
. . . . . . . . . .
Removal
6B–8
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection
6B–9
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation
6B–10
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Drive Belt and Cooling Fan
6B–11
. . . . . . . . . . . . . . .
Drive Belt and Associated Parts
6B–11
. . . . . . . . .
Inspection
6B–11
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation
6B–11
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Main Data and Specifications
6B–12
. . . . . . . . . . . . .
Special Tool
6B–13
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service Precaution
WARNING: THIS VEHICLE HAS A SUPPLEMENTAL
RESTRAINT SYSTEM (SRS). REFER TO THE SRS
COMPONENT AND WIRING LOCATION VIEW IN
ORDER TO DETERMINE WHETHER YOU ARE
PERFORMING SERVICE ON OR NEAR THE SRS
COMPONENTS OR THE SRS WIRING. WHEN YOU
ARE PERFORMING SERVICE ON OR NEAR THE SRS
COMPONENTS OR THE SRS WIRING, REFER TO
THE SRS SERVICE INFORMATION. FAILURE TO
FOLLOW WARNINGS COULD RESULT IN POSSIBLE
AIR BAG DEPLOYMENT, PERSONAL INJURY, OR
OTHERWISE UNNEEDED SRS SYSTEM REPAIRS.
CAUTION: Always use the correct fastener in the
proper location. When you replace a fastener, use
ONLY the exact part number for that application.
ISUZU will call out those fasteners that require a
replacement after removal. ISUZU will also call out
the fasteners that require thread lockers or thread
sealant. UNLESS OTHERWISE SPECIFIED, do not
use supplemental coatings (Paints, greases, or other
corrosion inhibitors) on threaded fasteners or
fastener joint interfaces. Generally, such coatings
adversely affect the fastener torque and the joint
clamping force, and may damage the fastener. When
you install fasteners, use the correct tightening
sequence and specifications. Following these
instructions can help you avoid damage to parts and
systems.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст