Isuzu KB P190. Manual — part 1189
Manual Transmission (MUX) 7B1-37
5. Use the remover 5-8840-2757-0 (2) and sliding
hammer 5-8840-0084-0 (1) to remove the output
front bearing outer race from the rear case.
6. Use the remover 5-8840-2757-0 (2) and sliding
hammer 5-8840-0084-0 (1) to remove the output
rear bearing outer race from the rear case.
Installation
1. Use the installer 5-8522-0053-0 (1) and grip 5-
8840-0007-0 (2) to install the output rear bearing
outer race to the rear case.
2. Use the installer 5-8840-2850-0 (1) and grip 5-
8840-0007-0 (2) to install the output front bearing
outer race to the rear case.
3. Install the oil nozzle to the rear case.
Important:
Convex of oil nozzle must be assembled in guide part
of rear case.
4. Install the counter shaft end roller bearing to the
rear case.
5. Install the new snap ring to the rear case.
• Never reinstall the used snap ring.
Notice:
The snap ring must be assembled in groove of rear
case surely.
RTW77BSH002201
1
2
RTW77BSH002101
1
2
RTW75CSH001401
2
1
RTW75CSH001501
2
1
7B1-38 Manual Transmission (MUX)
6. Use the installer 5-8840-2848-0 (1) to install the
linear ball bearing to the rear case.
• The linear ball bearing to be pressed fit to front
boss side.
• The linear ball bearing must be pressed at
marked side.
RTW77BSH003101
1
Manual Transmission (MUX) 7B1-39
End Cover Assembly
Component
Legend
1. Rear oil seal (4x2 model)
2. End cover (4x2 model)
3. Rear oil seal (4x4 model)
4. End cover (4x4 modeel)
Removal
1. Remove the rear oil seal from the end cover, and
discard the used oil seal.
Installation
1. Use the installer 5-8840-2786-0 to install the new
rear oil seal to the end cover. (4x2 model)
Use the installer 5-8840-2282-0 (1) to install the
new rear oil seal to the end cover. (4x4 model)
• Never reinstall the used oil seal.
• Apply engine oil to new rear oil seal outer
surfaces, and apply grease (BESCO L-2 or
equivalent) to the oil seal lip.
• At press fitting the oil seal, to be careful not to
inflict lip of it.
RTW77BSF000501
1
2
3
4
RTW75CSH001301
1
7B1-40 Manual Transmission (MUX)
Input Shaft Assembly
Component
Legend
1. 3rd input collar
2. 5th input collar
3. Input middle bearing
4. Oil catch impeller
5. Input shaft
Removal
1. Use a bench press to remove the 3rd input collar
from the input shaft.
RTW77BMF001401
3
2
1
4
5
RTW75CSH000101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст