Isuzu KB P190. Manual — part 127
4C1-4 FRONT WHEEL DRIVE
SPECIAL PARTS FIXING NUTS AND BOLTS
FRONT DRIVE AXLE AND PROPELLER SHAFT
N
⋅m (kgf⋅m/lb⋅ft)
RTW74CMF000101
FRONT WHEEL DRIVE 4C1-5
FRONT DIFFERENTIAL
N
⋅m (kgf⋅m/lb⋅ft)
RTW440LF000901
4C1-6 FRONT WHEEL DRIVE
RECOMMENDED LIQUID GASKET
Type Brand
Name
Manufacture Remarks
RTV*
Silicon Base
ThreeBond 1207B
ThreeBond 1207C
ThreeBond 1215
Three Bond
Three Bond
Three Bond
For Engine Repairs
For Axle Case
Repairs, T/M
Water Base
ThreeBond 1141E
Three Bond
For Engine Repairs
Solvent
ThreeBond 1104
BelcoBond 4
BelcoBond 401
BelcoBond 402
Three bond
Isuzu
Isuzu
Isuzu
For Engine Repairs
Anaerobic
LOCTITE 515
LOCTITE 518
Loctite
Loctite
All
* RTV : Room Temperature Vulcanizer
Note :
1. It is very important that the liquid gaskets listed above or their exact equivalent be used on the vehicle.
2. Be careful to use the specified amount of liquid gasket.
Follow the manufacture's instructions at all times.
3. Be absolutely sure to remove all lubricants and moisture from the connecting surfaces before applying
the liquid gasket.
The connecting surfaces must be perfectly dry.
4. LOCTITE 515 and LOCTITE 518 harden upon contact with a metal surface.
Do not apply LOCTITE 515 or LOCTITE 518 between two metal surfaces having a clearance of greater
than 0.25 mm (0.01 in). Poor adhesion will result.
RECOMMENDED THREAD LOCKING AGENTS
LOCTITE Type
LOCTITE Color
Application Steps
LOCTITE 242
Blue
1. Completely remove all lubricant and moisture from the bolts and
the female threaded surfaces of the parts to be joined.
The surfaces must be perfectly dry.
LOCTITE 262
Red
2. Apply LOCTITE to the bolts.
LOCTITE 270
Green
LOCTITE 271
Red
3. Tighten the bolts to the specified torque.
4. Wait at least on hour before continuing the installation procedure.
FRONT WHEEL DRIVE 4C1-7
SERVICING
Hub Bearing Preload at the Wheel Pin
4×4, 4×2 (High Ride Suspension) Model
N (kgf/lb)
New bearing and New oil seal
22 - 27
(2.2 - 2.8 / 4.9 - 6.2)
Reuse bearing and New oil seal
14 - 20
(1.4 - 2.0 / 3.1 - 4.5)
4×2 (Except High Ride Suspension) Model
N (kgf/lb)
New bearing and New oil seal
9.3 - 13.3
(0.95 - 1.36 / 2.09 – 3.00)
Reuse bearing and New oil seal
9.3 - 13.3
(0.95 - 1.36 / 2.09 – 3.00)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст