Isuzu KB P190. Manual — part 1270

8A-142 ELECTRICAL-BODY AND CHASSIS

REMOVAL AND INSTALLATION

FUEL GAUGE UNIT AND SENDER

ASSEMBLY

Removal

1. Remove the fuel gauge unit and sender assembly.

Refer to the “ENGINE FUEL” Section 6C of this Manual.

Installation

To install the fuel gauge unit and sender assembly, follow the
removal procedure in reverse order.
Pay close attention to the important points mentioned in the
following paragraphs.

Rubber Seal

Be absolutely sure that the fuel sender rubber seals are
correctly seated.

Connector

Be absolutely sure that the fuel gauge unit connector is
securely connected.
This will prevent a poor contact and an open circuit.

ELECTRICAL-BODY AND CHASSIS 8A-143

EXHAUST GAS RECIRCULATION (EGR) & GLOW; 4JA1T (L) ONLY

PARTS LOCATION (RHD)

RTW78AXF036501 & RTW78AMF001101

8A-144 ELECTRICAL-BODY AND CHASSIS

PARTS LOCATION (RHD)

RTW78AXF042701

ELECTRICAL-BODY AND CHASSIS 8A-145

PARTS LOCATION (LHD)

RTW78AXF036601 & RTW78AMF001101