Isuzu N-Series. Manual — part 957
7B-64 Automatic Transmission (Smoother)
27. Install the heat protector bracket (1) and heat
protector (2).
Tighten:
Bracket
45 N
⋅m (4.6 kg⋅m / 33.2 lb⋅ft)
Protector
23 N
⋅m (2.3 kg⋅m / 17 lb⋅ft)
28. Apply engine oil to the O-ring, and then install the
drain plug and O-ring.
Tighten:
39 N
⋅m (4.0 kg⋅m / 28.8 lb⋅ft)
29. Apply 5W-30 engine oil to the O-ring, and then
install the filler plug and O-ring.
Tighten:
39 N
⋅m (4.0 kg⋅m / 28.8 lb⋅ft)
30. Install the parking brake assembly.
• Refer to “Parking Brake”.
31. Apply engine oil to the O-ring, and then install the
coupling driver and O-ring.
32. Using a new lock nut, use the flange holder (5-
8840-2043-0) to tighten the lock nut.
Tighten:
289 N
⋅m (29.5 kg⋅m / 213.2 lb⋅ft)
• After tightening the lock nut to the specified
torque, stake it (2 points) securely using a
chisel (chisel tip shape: approx. 1 mm in radius
× 60 degrees) so the lock nut lip gap is aligned
with the V-groove of the shaft and is at least 5
mm, and the clearance between the V-groove
bottom and the nut lip is 2.5 mm or less.
Caution:
After caulking, check the caulking of the nut. If any
cracks are discovered, replace the lock nut and re-caulk.
N7A1084E
N7A1083E
N7A0294E
Automatic Transmission (Smoother) 7B-65
33. Install the parking brake drum and adjust hole
cover fixing bolt.
• Refer to “Parking Brake”.
N7A1072E
7B-66 Automatic Transmission (Smoother)
Tightening Torques
N7A1130E
Automatic Transmission (Smoother) 7B-67
Special Tools
Illustration
Tool No.
Tool Name
5-8840-0007-0
Grip
5-8840-2026-0
Bearing Installer
5-8840-2043-0
Flange Holder
5-8840-2750-0
Oil Seal Installer
5-8840-2755-0
Busing Remover and
Installer
5-8840-2756-0
Oil Seal Installer
5884000070
5884020260
5884020430
5884027500
5884027550
5884027560
5-8840-2757-0
Bearing Remover
5-8840-2798-0
Wrench
5-8840-2802-0
Brushing Puller
Illustration
Tool No.
Tool Name
5884027570
5884027980
5884028020
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст