Isuzu N-Series. Manual — part 5
POWER TAKE OFF 00-15
Legend
1. Cylinder main unit
2. Bypass valve
3. To oil tank
4. From oil pump (high pressure)
5. Air bleeding plug
NPA0028E
00-16 POWER TAKE OFF
CONTROL CABLE (FOR REAR DUMP TRUCK)
Removal and Installation
Removal Steps
Notice:
Because a three-rotation dump truck differs in the wiring
of a control cable from a rear dump truck, refer to the
notes on the replacement and adjustment of the control
cable for the three-rotation dump truck.
1. Lock Nut (Dump Lever Side)
• Set the dump lever to the “Down” position and
firmly lock the lever.
• Loosen the lock nut of the control cable and re-
move the cable tip from the boss portion of the
dump lever.
2. Clip (Inside Cab)
• Remove the clip from the instrument panel bot-
tom inside the cab.
Legend
1. Lock nut (dump lever side)
7. Cable stopper clip
2. Clip (inside cap)
8. Lock button
3. Lock nut (PTO side)
9. Dump lever
4. Special nut
10. PTO
5. Cable holder
11. Shift cap
6. Control cable
12. Oil pump
NPA0029E
POWER TAKE OFF 00-17
3. Lock Nut (PTO Side)
• Loosen the lock nut and move it toward the
truck front.
4. Special Nut
• Loosen the special nut and move it toward the
truck front.
5. Cable Holder
• Remove the bolt and remove the cable holder
from the PTO.
• Move the cable holder to the truck front and
provide clearance between the cable holder
and PTO.
Legend
1. Clip
2. Control cable
3. Boss portion
4. Lock nut
Legend
1. Control cable
2. Truck front
3. Lock nut
4. Special nut
5. PTO
6. Cable holder
NPA0030E
NPA0031E
Legend
1. Lock nut
2. Special nut
Legend
1. Rod end ball portion
2. Truck front
3. Cable holder
4. Bolt
5. Shift rod
6. PTO
NPA0032E
NPA0033E
00-18 POWER TAKE OFF
6. Control Cable
• Because the tip portion (PTO side) of the con-
trol cable is of a rod end ball type as shown in
the drawing, remove the cable end portion from
the cable connector groove on the PTO side
sliding it along the groove.
• Remove the cable holder from the control ca-
ble.
• Remove the control cable assembly from the
truck.
Installation Steps
1. Control Cable
• Set the dump lever to the “Down” position and
lock it.
• Install the control cable assembly in the truck.
• Move the lock nut (PTO side) and special nut of
the cable top the truck front side.
2. Cable Holder
• Assemble the cable holder in the control cable.
Legend
1. PTO
2. Rod end ball portion
3. Cable holder
4. Cable connector groove
NPA0034E
NPA0035E
Legend
1. Rod end ball portion
2. Control cable
3. Lock nut
4. Special nut
5. Cable holder
Legend
1. Special nut
2. Control cable
3. Truck front
4. Lock nut
NPA0036E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст