Isuzu N-Series. Manual — part 84
2-42 CAB AND FRAME
2. Insert the window regulator through the working
hole to tighten the 5 mounting screws to the speci-
fied torque.
Tighten:
Window regulator mounting screw to 7 N
⋅m (0.7 kg⋅m/
5.2 lb
⋅ft)
3. Glue the water-proof sheet with butyl tape secure-
ly. Check it for breakage.
Legend
1. Lip
4. Glass run
2. Sealant application range
5. Channel within panel
3. Sealant
N2A0076E
CAB AND FRAME 2-43
Door Lock Assembly
Removal
1. Door trim pad
2. Water-proof sheet
• Refer to “Window regulator” in this Section.
3. Glass run rear channel
• Pull out the 2 mounting screws.
4. Door lock assembly
• Disconnect each link and remove the 3 mount-
ing screws.
Installation
For installation, reverse the removal procedure taking
the following points into consideration.
1. Tighten the door lock assembly to the specified
torque.
Tighten:
• 15 N
⋅m (1.5 kg⋅m/11.1 lb⋅ft)
2. After installation, check the operation.
Legend
1. Door trim pad
3. Glass run rear channel
2. Water-proof sheet
4. Door lock assembly
N2A0077E
2-44 CAB AND FRAME
Fixing Torque
Legend
1. Door inside lock knob
2. Door inside handle
3. Door lock assembly
4. Door lock switch connector
5. Door lock cylinder
6. Door outside handle
N2A0078E
N2A0079E
CAB AND FRAME 2-45
Door Outside Handle and Door Lock Cylinder
Removal
1. Door trim pad
2. Water-proof sheet
• Refer to “Window regulator” in this Section.
3. Door outside handle (1)
• Disconnect the link and remove the 2 mounting
bolts.
4. Door lock cylinder
• Disconnect the link and pull out the clip.
Legend
1. Door trim pad
4. Door lock cylinder
2. Water-proof sheet
5. Clip
3. Door outside handle
N2A0080E
N2A0081E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст