Isuzu N-Series. Manual — part 91
2-70 CAB AND FRAME
Fixing Torque
Front Center Seat Belt and Assistant’s side
Seat Belt Buckle
Removal
1. Assistant’s seat cushion (three-passenger vehicle)
• Refer to “Center and Passenger Side” in Seat
Section of Cab Repair Manual.
2. Fixing bolt (1)
3. Passenger side seat belt buckle (2)
4. Center seat belt (3)
Installation
For installation, reverse the removal procedure taking
the following points into consideration.
1. Apply the sealant (1) around the fixing bolt mount-
ing hole.
Sealant: TOKIWA CHEMICAL INDUSTRY 770GA or
equivalent
2. Install the anchor parallel to the traveling direction
of vehicle.
3. Tighten the fixing bolts to the specified torque.
Tighten:
Fixing bolt to 44 N
⋅m (4.5 kg⋅m/32.5 lb⋅ft)
N2A0117E
N2A0118E
CAB AND FRAME 2-71
Fixing Torque
N2A0117E
2-72 CAB AND FRAME
Rear Seat Belt (Crew Cab Model)
Component
Removal
1. Seat belt lower anchor bolt
2. Rear pillar lower trim cover
• Remove the 2 clips and pull it upward.
3. Through anchor cover
4. Seat belt upper anchor bolt
5. Retractor fixing bolt
• Remove the bolt, and pull the retractor upper
bracket from panel to remove it.
Installation
For installation, refer to “Tongue Side Seat Belt (Single
Cab Model)” in this Section, and reverse the removal
procedure.
Legend
1. Rear pillar lower trim cover
5. Seat belt lower anchor bolt
2. Through anchor cover
6. Retractor fixing bolt
3. Seat belt upper anchor bolt
7. Bracket
4. Rear seat belt assembly
8. Clip
N2A0120E
CAB AND FRAME 2-73
Fixing Torque
N2A0121E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст