Isuzu N-Series. Manual — part 88
2-58 CAB AND FRAME
Fixing Torque
NKR
NPR, NQR
13 (1.3 / 9.6)
N.m (kg.m / lb.ft)
N2A0096E
13 (1.3 / 9.6)
N.m (kg.m / lb.ft)
N2A0228E
CAB AND FRAME 2-59
INTERIOR TRIM
Front Pillar Trim Cover
Removal
1. Front grip (3)
• Remove the 2 mounting screws.
Caution:
These screws are coated with Loctite. When removing
them, take care not to damage their heads.
2. Front pillar trim cover (1)
• Remove the one clip at the position (2) and peel
off the two-sided adhesive tape at the position
(5) shown in the figure.
For the high cab or wide cab, remove the clip
(4).
Installation
For installation, reverse the removal procedure taking
the following point into consideration.
• Use a new two-sided adhesive tape and stick it se-
curely by press at installation.
N2A0097E
2-60 CAB AND FRAME
Header Shelf
Removal
1. Battery ground cable
2. Room lamp/mirror
• Remove the lens and remove 2 mounting
screws and connector.
3. Sun visor/grommet
• Remove the 2 mounting screws. For a custom
vehicle, a sun visor is mounted on each of the
left and right sides.
4. Mounting screw
• Slide the left-hand 1 screws and right-hand 1
screws and the roof ventilator cover backward,
then pull them out. Remove the one screw in
the center of the rear side.
5. Header shelf assembly
6. Center bracket
• Remove the 2 mounting screws and 1 nut.
(With roof ventilation)
• Remove the 2 clips. (Without roof ventilation)
7. Side bracket
Legend
1. Side bracket
6. Screw
2. Center bracket
7. Grommet
3. Bracket cover (without roof ventilation)
8. Clip
4. Screw
9. Room lamp/mirror
5. Header shelf assembly
10. Sun visor/holder
N2A0100E
CAB AND FRAME 2-61
• Remove the 2 mounting screws each.
Installation
For installation, reverse the removal procedure.
Head Lining (Single Cab Model)
Component
Legend
1. Roof ventilator grille (High cab, wide cab; Option
equipment)
8. Coat hanger
9. Assist grip
2. Insulator
10. Sun visor/holder/grommet (Standard cab)
3. Rear pillar upper trim cover (Option equipment)
11. Room lamp/mirror (Standard cab)
4. Body side finisher (Option equipment)
12. Header shelf (High cab, wide cab except limited
model)
5. Head lining (Option equipment)
6. Clip
13. Front grip/front pillar trim cover
7. Rear retainer/clip (High cab, wide cab option
equipment)
N2A0101E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст