Isuzu N-Series. Manual — part 1178
SEAT BELT 9A-11
Rear Seat Belt (Crew Cab Model)
Components
Legend
1. Rear pillar lower trim cover
2. Through anchor cover
3. Seat belt upper anchor bolt
4. Rear seat belt assembly
5. Seat belt lower anchor bolt
6. Retractor fixing bolt
7. Bracket
8. Clip
Removal
1. Remove the seat belt lower anchor bolt.
2. Remove the rear pillar lower trim cover.
• Remove the 2 clips and pull it upward.
3. Remove the through anchor cover.
4. Remove the seat belt upper anchor bolt.
5. Remove the retractor fixing bolt.
• Remove the bolt and pull the retractor upper
bracket from panel to remove.
Installation
For installation, refer to “Tongue Side Seat Belt (Single
Cab Model)” in this section, and reverse the removal
procedure.
N2A0120E
9A-12 SEAT BELT
Fixing Torque
N2A0121E
SEAT BELT 9A-13
Rear Seat Belt Buckle and Rear Center Seat Belt/Buckle (Narrow Cab
Model)
Components
Legend
1. Rear seat belt buckle (RH)
2. Rear center seat belt
3. Rear center belt buckle
4. Rear seat belt buckle (LH)
5. Rear seat cushion
Removal
1. Fold the rear seat cushion.
• Pull out each seat belt buckle and seat belt from
the interval of the seat cushion and release the
lock lever of rear seat cushion stay to fold it.
2. Remove the fixing bolt of each seat belt.
Installation
For installation, reverse the removal procedure taking
the following points into consideration.
1. Apply the sealant (1) around the fixing bolt mount-
ing hole on the floor part (2).
Sealant TOKIWA CHEMICAL INDUSTRY 770GA or
equivalent
N2A0233E
N2A0109E
9A-14 SEAT BELT
2. Install the anchor parallel to the traveling direction
of vehicle.
3. Tighten the fixing bolts to the specified torque.
Tighten:
Fixing bolts to 44 N
⋅m (4.5 kg⋅m / 32.5 lb⋅ft)
Caution:
Install the anchor bracket (2) so that it may not run on
the anchor detent bead (1).
Fixing Torque
N2A0124E
44 (4.5 / 32.5)
N.m (kg.m / lb.ft)
N2A0234E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст