Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 586
3C–8
FRONT SUSPENSION
Torsion Bar
Torsion Bar and Associated Parts
410RS003
Legend
(1) Adjust Bolt, End Piece and Seat
(2) Height Control Arm
(3) Torsion Bar
Removal
1. Raise the vehicle and support the frame with suitable
safety stands.
2. Apply the setting marks(1) to the adjust bolt and end
piece, then remove adjust bolt, end piece and seat.
410RS004
FRONT SUSPENSION
3C–9
3. Apply the setting marks(2) to the height control arm
and torsion bar, then remove height control arm.
410RS005
4. Apply the setting marks(3) to the torsion bar and
lower control arm, then remove torsion bar.
410RS006
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D
Torsion bar
D
Height control arm
D
Adjust bolt
D
Rubber seat
Installation
1. Apply grease to the serrated portions, then install
torsion bar. Make sure the bars are on their correct
respective sides and align the setting marks(3).
410RS007
410RS006
3C–10
FRONT SUSPENSION
2. Apply grease to the portion that fits into the bracket
then install height control arm and align the setting
marks(2).
410RS005
3. Apply grease to the bolt portion of the end piece(4).
Apply grease to the portion of the seat(5) that fits into
the bracket.
410RS008
4. Apply grease to the serrated portions.
5. Install adjust bolt and seat, then turn the adjust bolt to
the setting mark(1) applied during disassembly.
NOTE: Adjust the trim height. Refer to Front End
Alignment Inspection and Adjustment in Steering section.
410RS004
FRONT SUSPENSION
3C–11
Knuckle
Knuckle and Associated Parts
410RW001
Legend
(1) Torsion Bar
(2) Lower Ball Joint, Nut and Cotter Pin
(3) Back Plate
(4) Knuckle Assembly
(5) Knuckle
(6) Needle Bearing
(7) Thrust Washer
(8) Oil Seal
(9) Upper Ball Joint, Nut and Cotter Pin
(10) Wheel Speed Sensor
Removal
1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
3. Remove the brake caliper. Refer to Disc Brakes in
Brake section.
4. Remove the hub assembly. Refer to Front Hub and
Disk in Driveline/Axle section.
5. Remove outer track rod from the knuckle. Refer to
Outer Track Rod Assembly Replacement in Steering
section.
6. Remove the speed sensor from the knuckle.
7. Loosen torsion bar by height control arm adjust bolt,
then remove torsion bar. Refer to Torsion Bar
Replacement in this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст