Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1679
EXTERIOR/INTERIOR TRIM
8J–23
Wheel Arch Molding (LWB)
Wheel Arch Molding and Associated Parts
620RY00005
EndOFCallout
Removal
1. Remove the front mud flap and front wheel arch
molding.
• Refer to Wheel Arch Molding (SWB) in this
section.
2. Remove the rocker wheel arch extension.
• Remove the fixing bolt (4) and screw (3). Pull out
the extension with the two clips (1) from the
rocker outer panel.
3. Remove the quarter panel wheel arch molding.
• Remove the three fixing screws (2) and pull out
the molding with the three clips (1) from the
quarter outer panel.
4. Remove the rear wheel arch molding.
• Remove the three fixing screws (5) of the back of
the door panel and pull out the molding with the
three clips (1) from the door outer panel.
620RY00003
Legend
(1) Front Wheel Arch Molding
(2) Front Mud Flap
(3) Rocker Wheel Arch Extension
(4) Rear Wheel Arch Molding
(5) Quarter Panel Wheel Arch Molding
8J–24
EXTERIOR/INTERIOR TRIM
Installation
To install, follow the removal steps in the reverse order.
Fuel Filler Door
Parts Location
686RW010
EndOFCallout
Removal
1. Open the fuel filler door.
2. Remove the fuel filler door.
• Remove the two fixing screws.
3. Pull out the fuel filler door buffer.
4. Pull out the fuel filler hinge buffer.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the fuel filler door to match the basic hole.
2. Adjust the clearance between outer quarter panel
(1) and fuel filler door (2).
686RX003
Legend
(1) Fuel Filler Door Fixing Screw
(2) Basic Hole
(3) Fuel Filler Door Buffer
(4) Fuel Filler Door
(5) Fuel Filler Door Hinge Buffer
EXTERIOR/INTERIOR TRIM
8J–25
Roof Rail
Parts Location
660R100001
EndOFCallout
Removal
1. Remove the front and rear roof rail cover.
• Pry the roof rail covers.
2. Remove the roof rail sub assembly.
• Remove the four fixing bolts at each roof rail.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the roof rail sub assembly fixing bolts to the
specified torque.
Torque 8 N·m (69 lb in)
Legend
(1) Roof Rail Fixing Bolt
(2) Rear Roof Rail Cover
(3) Roof Rail Sub Assembly
(4) Front Roof Rail Cover
8J–26
EXTERIOR/INTERIOR TRIM
License Plate Garnish
Parts Location
803RY00004
EndOFCallout
Removal
1. Disconnect the battery ground cable.
2. Remove the license plate light.
• Remove the left and right license plate light fixing
screws. Disconnect the harness connectors.
3. Remove the tailgate trim cover assembly (3).
• Remove the two screws (2) holding the hatchgate
lock assembly (1) first and the two screws fixing
the trim cover assembly. Pull up the trim cover
while detaching the clips from tailgate panel.
683RW001
Legend
(1) Tailgate Trim Cover Assembly
(2) Tailgate Assembly
(3) Clip
(4) License Plate Garnish Assembly
(5) License Plate Light Assembly
(6) License Plate Light Harness Connector
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст