Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1638
8E–4
METER AND GAUGE
Table for Meter/Gauge Connector Terminal Connections
821RY00053
EndOFCallout
Legend
(1)
Connector A
(2)
Connector B
(3)
Connector C
METER AND GAUGE
8E–5
Connector A
Terminal
Function
1
—
2
Intelligent suspension indicator light
3
—
4
—
5
—
6
—
7
—
8
A/T shift indicator light “3"
9
A/T shift indicator light “D"
10
A/T shift indicator light “2"
11
SRS – air bag warning light
12
Ground
13
Battery
14
Stater switch
15
A/T oil temperature warning light
16
Seat belt indicator light
17
Charge warning light
18
—
19
—
20
—
21
A/T shift indicator light “L"
22
ABS warning light
23
4WD indicator light
24
—
25
Reduced power warning light
26
Oil pressure warning light
27
Check trans warning light
28
MIL(check engine) warning light
29
—
30
Engine coolant temperature gauge
Connector B
Terminal
Function
1
A/T shift indicator light “R"
2
A/T shift indicator light
3
A/T shift indicator light “N"
4
A/T shift indicator light “P"
5
Illumination light
6
Engine revolution pulse
7
Speed sensor pulse
8
Turn signal indicator light (LH)
9
Brake warning light
10
High beam indicator light (+)
11
High beam indicator light (–)
12
Turn signal indicator light (RH)
13
Turn signal indicator light
14
—
15
Illumination light
16
Ground
Connector C
Terminal
Function
1
Starter switch
2
Upshift indicator light
3
Fuel gauge
4
Low fuel warning light
5
Cruise set indicator light
6
Upshift indicator light
7
—
8
—
9
—
10
Sport mode indicator light
11
—
12
Winter drive indicator light
13
Power drive indicator light
14
—
8E–6
METER AND GAUGE
Removal
1. Disconnect the battery ground cable.
2. Remove the Dash Side Trim Panel –LH.
3. Remove the lower cover Assembly(1).
• Refer to the Instrument Panel Assembly in Body
Structure section.
4. Remove the meter cluster Assembly(2).
• Refer to the Instrument Panel Assembly in Body
Structure section.
821RW253
5. Remove the meter assembly(3).
• Remove four fixing screws.
• Disconnect the meter connector.
825RW197
CAUTION: The removed meter assembly should
be placed upright or with its face side up.
Installation
To install, follow the removal steps in the reverse order.
Warning Light Bulb and Indicator Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the meter assembly.
• Refer to the Meter Assembly removal steps in
Meter and Gauge section.
3. Remove the bulb.
• Hold the bulb socket by hand, rotate it
counterclockwise and pull it out.
Installation
To install, follow the removal steps in the reverse order.
METER AND GAUGE
8E–7
A/T Shift Indicator Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Pry up the bended portions(2) of the metal cover(1).
821RY00060
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст