Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 538
1A–20 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
Blower Assembly
Blower Assembly and Associated Parts
873RY00003
Legend
(1) Electro Thermo Connector
(2) Blower Motor Connector
(3) Resistor Connector
(4) Dash Side Trim Panel (RH)
(5) Blower Assembly
(6) Duct
(7) Evaporator Assembly (A/C only)
(8) Heater Unit
(9) Instrument Panel Assembly
Removal
1. Disconnect the battery ground cable.
2. Discharge and recover refrigerant (with air
conditioning).
D
Refer to Refrigerant Recovery in this section.
3. Remove instrument panel assembly.
D
Refer to Instrument Panel Assembly in Body and
Accessories section.
4. Disconnect resistor connector.
5. Remove duct.
6. Remove evaporator assembly (A/C only).
D
Refer to Evaporator Assembly in this section.
7. Remove dash side trim panel (RH).
8. Disconnect blower motor connector.
9. Remove blower assembly.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–21
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1. Adjust the control lever assembly cables.
D
Refer to Control Lever Assembly in this section.
Blower Link Unit and / or Mode door
Disassembled View
873RS001
Legend
(1) Upper Case
(2) Mode Door
(3) Lower Case
(4) Sub Lever
(5) Door Lever
(6) Blower Assembly
Removal
1. Disconnect the battery ground cable.
2. Discharge and recover refrigerant (with air
conditioning).
D
Refer to Refrigerant Recovery in this section.
3. Remove blower assembly.
D
Refer to Blower Assembly in this section.
1A–22 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
4. Remove lower case.
5. Separate the upper case and slit the lining parting
face with a knife.
873RS002
6. Pull out the mode door while lifting up the catch of
door lever.
7. Remove sub-lever.
8. Remove door lever.
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Apply grease to the door lever and to the abrasive
surface of the upper case.
2. Apply an adhesive to the parting face of the lining
when assembling the upper case.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–23
Blower Motor
Blower Motor and Associated Parts
873R200006
Legend
(1) Blower Motor Connector
(2) Blower Motor Assembly
(3) Attaching Screw
Removal
1. Disconnect the battery ground cable.
2. Remove blower motor connector.
3. Remove attaching screw.
4. Remove blower motor assembly.
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст