Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1616
LIGHTING SYSTEM
8A–7
Fog Light Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the fog light assembly (1).
D
Disconnect the connector.
D
Remove two nuts from the bracket.
825RY00065
Installation
To install, follow the removal steps in the reverse order.
CAUTION: After installing the fog light, be sure to
adjust the fog light aim.
Fog Light Adjustment
Vertical Adjustment
Turn the adjusting screw (1) with a screwdriver to adjust
the aim of the fog light vertically.
825RY00067
Side Marker Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the radiator grille.
D
Refer to Engine Hood and Fender in Body Structure
section.
3. Remove the front combination light (2).
D
Remove three screws.
4. Remove the bulb (1).
D
Remove the side marker light socket by turning it
counterclockwise.
D
Remove the bulb by turning it counterclockwise
while pushing it at the same time.
825RW067
Installation
To install, follow the removal steps in the reverse order.
8A–8
LIGHTING SYSTEM
Taillight Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the rear combination light assembly (1).
D
Remove three screws.
D
Pull out the rear combination light assembly toward
you.
803RY00005
3. Remove the bulb (1).
D
Remove the taillight socket by turning it
counterclockwise.
D
Remove the bulb by turning it counterclockwise
while pushing it at the same time.
825RW069
Installation
To install, follow the removal steps in the reverse order.
License Plate Light Bulb (Bumper Type)
Removal
1. Disconnect the battery ground cable.
2. Remove the lens cover (3).
D
Remove two screws.
3. Remove the lens (2).
4. Remove the bulb (1).
D
Pull out the bulb from the socket.
825RW070
Installation
To install, follow the removal steps in the reverse order.
LIGHTING SYSTEM
8A–9
License Plate Light Bulb (Tailgate Type)
Removal
1. Disconnect the battery ground cable.
2. Remove the lens cover (3).
D
Remove two screws.
3. Remove the bulb (2).
D
Pull out the bulb from the socket (1).
803RW014
Installation
To install, follow the removal steps in the reverse order.
Stoplight Bulb
Removal and Installation
Refer to Taillight Bulb in this section.
8A–10
LIGHTING SYSTEM
High Mounted Stoplight Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove the high mounted stoplight assembly (2).
D
Remove the cover (3).
D
Disconnect the connectors (1).
D
Remove two screws.
803RX001
Installation
To install, follow the removal steps in the reverse order.
High Mounted Stoplight Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the cover.
3. Remove the bulb (1).
D
Remove the socket by turning it counterclockwise.
825R100022
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст