Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 572
POWER ASSISTED SYSTEM
2A–17
Toe-in Adjustment
1. To adjust the toe-in angle, loosen the lock nuts(2) on
the outer track rods(1) and turn the outer track rods.
Turn both rods the same amount, to keep the steering
wheel centered .
Toe-in: 0
±
2 mm (0
±
0.08 in)
433RS001
2. Tighten the lock nut to the specified torque.
Torque: 118 N·m (87 lb ft)
Maximum Steering Angle Adjustment
The maximum steering angle of the front wheels can be
adjusted with the stop bolts under the frame side
members.
433RS002
1. Position each front wheel on the turning radius gauge
in a straight-ahead position.
2. Set the parking brake firmly.
3. Adjust the inside wheel angle of each side with the
stop bolts.
NOTE: The maximum protruding length(1) of stop bolt(3)
from the lock nut(2) should be 10 mm or less
433RS003
4. Similarly adjust the inside wheel angle of the other
side with stop bolt.
Inside wheel: 34
°
(+0
°
to –2
°
)
Outside wheel: 32
°
NOTE: Maximum steering angles should be set after
adjusting front wheel alignment.
5. If the stop between the lower link end and the knuckle
comes ahead of the stop bolt, adjust the stop bolt so
that inner stop bolt touches the drop arm (relay lever).
433RS004
6. Tighten the lock nut to the specified torque.
Torque: 23 N·m (17 lb ft)
2A–18
POWER ASSISTED SYSTEM
Main Data and Specifications
General Specification
Caster
2
°
10’
±
45’
Camber
0
°
±
30’
King pin inclination
12
°
30’
±
30’
Toe-in
0
±
2 mm (0
±
0.08 in)
Max. steering angle
inside
34
°
(+0
°
to –2
°
)
outside
32
°
Torque Specification
E03RS001
POWER ASSISTED SYSTEM
2A–19
Special Tools
ILLUSTRATION
TOOL NO.
TOOL NAME
J–29877–A
Tester:
Power steering
J–39213
Adapter:
Power steering tester
J–29107
Remover:
Pitman arm
J–26508
Installer:
Extension housing oil
seal
2A–20
POWER ASSISTED SYSTEM
Power Steering Gear
Power Steering Gear and Associated Parts
431RS002
Legend
(1) Pipe
(2) Universal Joint Bolt
(3) Pitman Arm
(4) Nut
(5) Gear Box Mounting Bolt and Nut
(6) Gear Box
Removal
1. Remove the stone guard.
2. Remove the lower fan shroud. Refer to Radiator in
Engine section.
3. Disconnect stabilizer bar at the stabilizer links.
Loosen stabilizer bracket fixing nuts.
4. Remove pipe.
5. Remove nut.
6. Use Pitman arm remover J–29107 to remove pitman
arm.
433RS005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст