Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 509

SUPPLEMENTAL RESTRAINT SYSTEM

9J–19

J–39200 DVM

The J–39200 DVM is the preferred DVM for use in SRS
diagnosis and repair. However, J–34029–A may be used
if J–39200 is not available. No other DVMs are approved
for SRS diagnosis and repair.

901RS153

Scan Tool

The Tech 2 is used to read and clear SRS Diagnostic
Trouble Codes (DTCs). Refer to the Tech 2 Operator’s
Manual for specific information on how to use the Tech 2.

901RW176

J–35616–A Connector Test Adapter Kit

The J–35616–A Connector Test Adapter Kit must be used
whenever a diagnostic procedure requests checking or
probing a terminal. Using the appropriate adapter will
ensure that no damage to the terminal will occur from the
DVM prove, such as spreading or bending. The adapter
will also give an idea of whether contact tension is
sufficient, helping to find an open or intermittent open due
to poor terminal contact.

901RS151

J–42986 SRS Deployment Tool

The J–42986 SRS Deployment Tool must be used for
deployment of the undeployed air bag.

901RW106

SUPPLEMENTAL RESTRAINT SYSTEM

9J–20

J–42987 SRS Adapter For Load Tool

The J–42987 SRS Adapter be used for connect previous
load tool to new SRS system when inspect SRS system
harness.

901RW107

J–41497 SRS Deployment Fixture

The J–41497 SRS Deployment Fixture must be used for
deployment of the undeployed passenger side air bag.

901RW088

SUPPLEMENTAL RESTRAINT SYSTEM

9J–21

Tech 2 Scan Tool

From 2002 AXIOM (UP), dealer service departments are
recommended to use Tech 2. Please refer to Tech 2 scan
tool user guide.

901RW180

Legend

(1) PCMCIA Card
(2) RS 232 Loop Back Connector

(3) SAE 16/19 Adaptor
(4) DLC Cable
(5) Tech–2

SUPPLEMENTAL RESTRAINT SYSTEM

9J–22

Getting Started

D

Before operating the Isuzu PCMCIA card with the
Tech 2, the following steps must be performed:

1. The Isuzu System PCMCIA card (1) inserts into the

Tech 2 (5).

2. Connect the SAE 16/19 adapter (3) to the DLC cable

(4).

3. Connect the DLC cable to the Tech 2 (5)
4. Make sure the vehicle ignition is off.
5. Connect the Tech 2 SAE 16/19 adapter to the vehicle

DLC.

060R200039

6. The vehicle ignition turns on.
7. Verify the Tech 2 power up display.

060RW009

NOTE: The RS232 loop back connector is only to use for
diagnosis of Tech 2 and refer to user guide of the Tech 2.

Operating Procedure
The power up screen is displayed when you power up the
tester with the Isuzu systems PCMCIA card. Follow the
operating procedure below.

060R100102