Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1033
EXTERIOR/INTERIOR TRIM
8J–17
11. Remove the quarter upper trim cover.
D
Remove the rear side clips of the trim cover and pry
the quarter upper trim cover retainers free from the
body panel.
687RS004
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. Tighten the seat belt anchor bolt to the specified
torque.
Torque: 39 N·m (29 lb ft)
8J–18
EXTERIOR/INTERIOR TRIM
Center Pillar and Roof Side Trim Cover
Center Pillar, Roof Side Trim Cover and Associated Parts
643RW003
Legend
(1) Roof Side Trim Cover
(2) Front Pillar Trim Cover
(3) Assist Grip (RH only)
(4) Adjust Shoulder Anchor Assembly
(5) Center Pillar Upper Trim Plate
(6) Door Sill Plate (Front and Rear)
(7) Center Pillar Lower Trim Cover
(8) Front Seat Anchor Bolt Cover and Anchor Bolt
(9) Center Pillar Assist Grip
(10) Assist Grip
(11) Rear Quarter Upper Trim Cover
Removal
1. Disconnect the battery ground cable.
2. Remove the door sill plate (front and rear).
3. Remove the center pillar lower trim cover (2).
D
Turn up the finisher (1) and pry the trim cover
retainers free from the body panel, then slide the
trim cover downward.
643RS003
EXTERIOR/INTERIOR TRIM
8J–19
4. Remove the front seat belt anchor bolt cover (3) and
the anchor bolt (4).
760RW006
5. Remove the center pillar upper trim cover (6).
D
Turn up the finisher (5) and pry the trim cover
retainers free from the body panel.
643RS004
6. Remove the center pillar assist grip.
7. Remove the seat belt anchor plate.
8. Remove the assist grip (7).
D
Open the both side of the assist grip cover (8) and
remove two fixing screws.
743RW004
9. Remove the roof side trim cover (9).
D
Turn up the finisher (10) and pry the trim cover
retainers free from the body panel.
643RS005
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. Install the seat belt anchor bolts to the specified
torque.
Torque: 39 N·m (29 lb ft)
8J–20
EXTERIOR/INTERIOR TRIM
Front Pillar Trim Cover
Front Pillar Trim Cover and
Associated Parts
743RS003
Legend
(1) Roof Side Trim Panel
(2) Assist Grip (RH only)
(3) Front Pillar Trim Panel
Removal
1. Remove the front pillar assist grip(1).
D
Open the both sides of the assist grip cover (2) and
remove the fixing screws and the front pillar assist
grip.
743RW003
2. Remove the front pillar trim cover (3).
D
Turn up the finisher (4) and pry the trim cover
retainers free from the body panel.
635RW001
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст