Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1651
8F–46
BODY STRUCTURE
5. Remove the door harness connection.
• Pull the door harness grommet out in order to
disconnect the door harness connection.
630RW004
6. Remove the rear door assembly.
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Align the door fitting to the body by referring to Front
Door Assembly in this section.
2. Tighten the door hinge bolts to the specified torque.
Torque : 34 N·m (25 lb ft)
3. Apply chassis grease to the check arm pin and the
door hinge moving surface.
BODY STRUCTURE
8F–47
Front Window Regulator, Glass and Glass Run
Parts Location
635R100001
EndOFCallout
Legend
(1) Glass Run
(2) Glass
(3) Window Regulator
(4) Waist Seal
(5) Outside Handle
(6) Locking Link
(7) Door Lock Assembly
(8) Waterproof Sheet
(9) Door Trim Panel
(10) Courtesy Light Lens
(11) Speaker Grille
(12) Grip Cover
(13) Inside Handle
(14) Power Window Switch/Window Regulator
Handle
(15) Speaker Assembly
(16) Tweeter
(17) Door Mirror Cover
(18) Door Mirror Assembly
8F–48
BODY STRUCTURE
Removal
1. Disconnect the battery ground cable.
2. Remove the power window switch/regulator handle.
• Pry out the power window switch and remove the
connectors.
635RW004
• To remove the regulator handle (1), remove the
clip (2) at the root of the handle by using wire with
hook.
631RW004
3. Remove the screw while pulling the inside lever
toward you and then remove the inside handle.
632RW003
4. Remove the speaker grille (3).
• Pull out the front side of the grille.
5. Remove the speaker assembly (2).
• Remove the 4 screws and disconnect the
speaker harness connector (1).
635RW002
BODY STRUCTURE
8F–49
6. Remove the door mirror cover.
7. Remove the grip cover.
8. Remove the 5 screws (1), (3) and pull out the trim
panel at the 6 clip positions (2).
635RW007
9. Remove the waterproof sheet.
10. Remove the 2 screws through the access hole and
pull out the glass upward.
631RW006
631RW007
11. Remove the window regulator.
• Disconnect the window regulator motor harness
connector, if equipped with power windows.
12. Remove the glass run.
• Pull the glass run (6) out from the door frame
groove.
631RS007
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст