Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 701
5C–48 POWER ASSISTED BRAKE SYSTEM
After refinishing, replace any rotor that does not meet the
minimum thickness of 16.97 mm (0.668 in). Do not use a
brake rotor that will not meet the specification.
Minimum wear dimension: 16.6 mm (0.654 in)
Refinish dimension: 16.97 mm (0.668 in)
420RW002
Rear Drum (In Disc) Inside Diameter
Check
Check the rear drum inside diameter by measuring at
more than two portions as shown in the illustration.
If the inside diameter is greater than the limit, replace the
rear rotor.
Standard: 210.0 mm (8.27 in)
Limit: 211.4 mm (8.32 in)
420RS035
5C–49
POWER ASSISTED BRAKE SYSTEM
Rear Disc Brake Caliper Assembly
Rear Disc Brake Caliper Assembly and Associated Parts
306RW007
Legend
(1) Brake Flexible Hose
(2) Clip
(3) Lock Bolt
(4) Support Bracket
(5) Guide Bolt
(6) Pad Assembly with Shim
(7) Caliper Assembly
Removal
1. Raise the vehicle and support with suitable safety
stands.
2. Remove wheel and tire assembly, refer to “Wheels
and Tires System” in Section 3E.
3. Remove the bolt and gaskets, then disconnect the
flexible hose from the caliper and after disconnecting
the flexible hose (1), cap or tape the openings to
prevent entry of foreign material.
306RW008
4. Since the brake fluid flows out from the connecting
coupler, place a drain pan under the vehicle.
5. Remove lock bolt (2).
6. Remove guide bolt (3).
306RW009
7. Remove caliper assembly.
8. Remove support bracket with pad assembly and take
care not to damage the flexible brake hose when
removing the support bracket.
9. Remove pad assembly (with shim) and mark the
lining locations if they are to be reinstalled.
5C–50 POWER ASSISTED BRAKE SYSTEM
10. Remove clip.
Installation
1. Install clip (4).
306RW010
2. Install pad assembly (with shim) and apply special
grease (approximately 0.2 g) to both contacting
surfaces of the inner shims (5). Wipe off extruded
grease after installing.
306RW011
Legend
(5) Inner Shim
(6) Wear indicator
3. Install support bracket and tighten the bolt (7) to the
specified torque.
Torque: 103 N·m (76 lb ft)
306RW012
4. Install caliper assembly.
5. Install lock bolt and guide bolt (8) and tighten the bolt
to the specified torque.
Torque: 44 N·m (32 lb ft)
306RW013
5C–51
POWER ASSISTED BRAKE SYSTEM
6. Install brake flexible hose, always use new gaskets
and be sure to put the hooked edge of the flexible
hose end into the anti–rotation cavity then tighten the
I–bolt (9) to the specified torque.
Torque: 35 N·m (26 lb ft)
302RW017
7. Install the wheel and tire assembly, refer to “Wheels
and Tires System” in Section 3E.
8. Bleed brakes. Refer to “Hydraulic Brakes” in this
section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст