Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 645
4C–6
DRIVE SHAFT SYSTEM
D
Place hub on a suitable work surface and remove
wheel studs, as required, using a hammer.
411RS004
Inspection and Repair
Check the following parts for wear, damage or other
abnormal conditions.
D
Hub
D
Hub bearing
D
Bearing outer race
D
Disc
D
Oil seal
Reassembly
1. Install wheel pin.
D
Place hub on a wood workbench or a block of wood
approx. 6” by 6” to protect the wheel stud ends and
threads.
D
Install wheel stud, using a hammer.
NOTE: Be sure wheel stud is started squarely and seats
completely.
411RS005
2. Align index marks(1) and install hub to disc.
411RS003
4C–7
DRIVE SHAFT SYSTEM
3. Install bolt.
Tighten the bolts to the specified torque.
Torque: 103 N·m (76 lb ft)
411RS021
4. Install outer bearing.
Install the outer race by driving it into the hub by using
installer J–36828 and grip J-8092.
901RW056
5. Install inner bearing.
Install the outer race by driving it into the hub by using
installer J–36829 and grip J–8092.
411RS023
6. Install oil seal by using installer J–36830 and grip
J–8092.
Apply Multipurpose grease NLGI No. 2 or equivalent
to the lip portion.
901RW057
4C–8
DRIVE SHAFT SYSTEM
7. Apply Multipurpose grease NLGI No.2 in the hub and
bearing.
Hub
35 g (1.23 oz)
Outer bearing
10 g (0.35 oz)
Inner bearing
15 g (0.53 oz)
8. Install hub nut by using wrench J–36827.
Turn the place where there is a chamfer in the tapped
hole to the outer side, and attach the nut.
901RW054
Preload Adjustment
1. Tighten the hub nut to 29.4 N·m (21.7 lb ft), then
loosen the nut to the full.
2. Tighten the hub nut to the value given below,
using a spring scale on the wheel pin.
Bearing Preload
New bearing and New
oil seal
19.6 – 24.5 N
(4.4 – 5.5 lb)
Used bearing and New
oil seal
11.8 – 17.7 N
(2.6 – 4.0 lb)
If the measured bearing preload is outside the
specifications, adjust it by loosening or tightening
the bearing nut.
411RS011
9. Install lock washer.
D
Turn the side with larger diameter of the tapered
bore to the vehicle outer side, then attach the
washer.
If the bolt holes in the lock plate are not aligned with
the corresponding holes in the nut, reverse the lock
plate. If the bolt holes are still out of alignment, turn
in the nut just enough to obtain alignment. Screw is
to be fastened tightly so its head may come lower
than the surface of the washer.
411RS012
10. Install the paking.
11. Install cover and tighten the cover bolt.
12. Install brake caliper and tighten fixing bolt.
4C–9
DRIVE SHAFT SYSTEM
Main Data and Specifications
Torque Specifications
E04RW00001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст