Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1624
WIPER/WASHER SYSTEM
8B–13
Rear Wiper Arm/Blade (Resin Top Model)
Removal
1. Remove the arm nut (2).
2. Remove the wiper arm/blade (1).
885RX003
Installation
Refer to Rear Wiper Motor in this section.
Rear Washer Nozzle
Removal
1. Remove the washer nozzle(1).
• Pull out the washer nozzle from the washer hose
(2).
885R100003
Installation
To install, follow the removal steps in the reverse order.
Rear Washer Spray Pattern
885R100002
EndOFCallout
Legend
(1) Washer Nozzle
(2) Spray Target
8B–14
WIPER/WASHER SYSTEM
Rear Washer Nozzle (Resin Top Model)
Removal
1. Remove the washer nozzle (1).
• Pull out the washer nozzle and disconnect the
washer hose.
885RX001
Installation
To install, follow the removal steps in the reverse order.
Rear Washer Spray Pattern
To install, follow the removal steps in the reverse order.
885R100005
EndOFCallout
Legend
(1) Washer Nozzle
(2) Spray Target
WIPER/WASHER SYSTEM
8B–15
Rear Wiper Blade Rubber (Spare Tire Storage-Tailgate Mounted)
Removal
1. Remove the wiper blade from the wiper arm.
2. Push out the wiper rubber from the wiper blade by
sliding it horizontally while holding down the rubber
on the wiper blade convex (1) side.
CAUTION: When the wiper blade has been
removed, wrap the tip of the wiper arm with cloth, to
avoid damaging the glass.
880RW022
Installation
1. Install the wiper blade rubber.
• Insert the tip of wiper rubber (2) from the opposite
side of removal in the arrow direction.
880RX001
• Check if the convex part (3) of wiper blade is
installed in the groove of the wiper rubber.
880RX002
8B–16
WIPER/WASHER SYSTEM
Rear Wiper Blade Rubber (Spare Tire Storage-Under Floor)
Removal
1. Push the wiper blade lock(1) while pulling the wiper
blade in the arrow direction as shown in the figure.
CAUTION: When the wiper blade has been
removed, wrap the tip of the wiper arm with cloth, to
avoid damaging the glass.
880RS011
2. Pull the end of rubber and remove the projection(3)
from the click of the blade stay (2).
880RS010
3. Pull the rubber out in the same direction.
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Install the click of the blade stay in the groove of the
new rubber and slide it in. Complete wiper blade
installation by pushing the click.
885RS002
2. Finally, check that the click of the stay has caught in
the hole of the rubber.
885RS001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст