Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1159
TRANSFER CASE
4D–5
4. Install the rear companion flange (2) and O–ring (2).
5. Use the companion flange holder J–8614–11 to
install a new end nut (2) and tighten to the specified
torque.
Torque: 167 N·m (123 lb ft)
6. Use the punch J–39209 to stake the end nut at two
spots.
NOTE: Be sure to confirm that there is no crack at the
staked portion of the end nut (2) after staking.
266RS001
266RW002
7. Connect the rear propeller shaft to the transfer case
and tighten to the specified torque.
Torque: 63 N·m 46 (lb ft)
4D–6
TRANSFER CASE
Transfer Case Assembly (A/T)
Transfer Case Assembly (A/T) and Associated Parts
260RW008
EndOFCallout
Removal
NOTE: Before removing transmission and transfer
assembly from vehicle, change the transfer mode to
2WD using the 4WD push button switch on dash panel.
1. Disconnect battery ground cable.
2. Remove transfer control lever knob (1).
Legend
(1) Transfer Control Lever Knob
(2) Lower Cluster Assembly
(3) Rear Console
(4) Center Console
(5) Grommet Assembly and Transfer Control Lever
(6) Transfer Protector
(7) Fairing Plate
(8) Rear Propeller Shaft
(9) Front Propeller Shaft
(10) Transfer Case Assembly
TRANSFER CASE
4D–7
3. Remove lower cluster assembly (2).
740RW021
4. Remove rear console (3).
256RW005
5. Remove center console (4).
256RW006
6. Remove grommet assembly and transfer control
lever (5).
256RW007
4D–8
TRANSFER CASE
7. Raise and support vehicle with suitable stands.
Drain transfer case fluid.
8. Remove transfer protector (6) and fairing plate (7).
150RW006
9. Remove rear propeller shaft (8) and front propeller
shaft (9).
NOTE: Apply alignment marks on the flange at both
front and rear sides.
10. Disconnect harness connectors and clip.
Connector: transfer switch, 2WD–4WD actuator,
speed sensor.
11. Support transmission case with a transmission jack.
12. Remove the top position bolt from transfer control
lever hole and others under the floor.
Remove transfer case (10) from the vehicle.
Installation
1. Apply a thin coat of molybdenum disulfide grease to
the input shaft spline as shown in the figure.
260RW001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст