Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 132
4C–28
DRIVE SHAFT SYSTEM
Special Tools
ILLUSTRATION
TOOL NO.
TOOL NAME
J–39378
Remover and Installer;
Front Axle mount
bushing
J– 26941
Remover; Bearing
needle
J–2619–01
Hammer; Sliding
J–41693
Installer; Oil seal
J–41694
Installer; Bearing needle
J–8092
Grip
ILLUSTRATION
TOOL NO.
TOOL NAME
J–36827
Wrench; Hub nut
J–36829
Installer; Inner bearing
J–36828
Installer; Outer bearing
J–36830
Installer; Oil seal
4C–29
DRIVE SHAFT SYSTEM
Propeller Shaft
General Description
401R200001
Legend
(1) Front Propeller Shaft
(2) Rear Propeller Shaft;
Aluminum Tube with Flange Yoke Type (for
4
×
2 model)
(3) Rear Propeller Shaft;
Steel Tube Type (for 4
×
4 model)
Torque is transmitted from the transmission to the axle
through the propeller shaft and universal joint assembles.
All propeller shafts are the balanced tubular type. A
splined slip joint is provided in some drivelines.
D
Since the propeller shaft is balanced carefully,
welding or any other modification is not permitted.
D
Alignment marks should be applied to each propeller
shaft before removal.
D
Park, turn the engine off and apply the parking brake
to secure the vehicle.
D
Carefully attach the propeller shaft to the vise, do not
overtighten the vise when securing the propeller
shaft, this may cause deformation.
4C–30
DRIVE SHAFT SYSTEM
Front Propeller Shaft
General Description
Since the propeller shaft is balanced carefully, welding or
any other modifications are not permitted.
Alignment marks should be applied to each propeller
shaft before removal.
401R200004
4C–31
DRIVE SHAFT SYSTEM
Front Propeller Shaft and Associated Parts
401R200006
Legend
(1) Bolt, and Washer (Front Axle Side)
(2) Front Propeller Shaft (with TOD)
(3) Bolt and Washer (Transfer Side)
(4) BJ Constant Velocity Joint
(5) LJ Constant Velocity Joint
Removal
1. Jack up the vehicle and support it on the chassis
stands.
2. Gear shift lever should be placed in neutral position
and parking brake released.
3. Remove the exhaust and transfer protectors.
NOTE: Apply alignment marks on the flange at the front
propeller shaft both front and rear side.
401RS020
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст