Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 917
7A–94
AUTOMATIC TRANSMISSION (4L30–E)
Extension Housing Assembly Oil Seal
Extension Housing Assembly Rear Oil Seal and Associated Parts
220RY00010
Legend
(1) Propeller Shaft
(2) End Nut and Companion Flange
(3) Oil Seal
(4) Mass
Removal
1. Disconnect the propeller shaft (1) and mass (4) from
the extension housing assembly.
2. Remove end nut and companion flange (2), using the
companion flange holder J–8614–11.
266RW001
3. Use the universal puller to remove the companion
flange and O–ring.
4. Remove the oil seal from the extension housing
assembly.
Installation
1. Install oil seal and apply engine oil to the oil seal outer
surfaces.
2. Apply the recommended grease (BESCO L2) or
equivalent to the oil seal lip.
3. Use the oil seal installer J–39208 to install the rear
seal (3) to the extension housing assembly.
220RS016
7A–95
AUTOMATIC TRANSMISSION (4L30–E)
4. Install the companion flange (2) and O–ring (2).
5. Use the companion flange holder J–8614–11 to install
a new end nut (2) and tighten to the specified torque.
Torque: 167 N·m (123 lb ft)
6. Use the punch J–39209 to stake the end nut at two
spots.
NOTE: Be sure to confirm that there is no crack at the
staked portion of the end nut (2) after staking.
266RS001
266RW002
7. Connect the mass and propeller shaft to the
extension housing assembly and tighten to the
specified torque.
Torque: 63 N·m 46 (lb ft)
7A–96
AUTOMATIC TRANSMISSION (4L30–E)
Extension Housing Assembly
Extension Housing Assembly and Associated Parts
260RY00006
Legend
(1) Propeller Shaft
(2) Mass
(3) Extension Housing Assembly
7A–97
AUTOMATIC TRANSMISSION (4L30–E)
Removal
1. Disconnect battery ground cable.
2. Raise and support vehicle with suitable stands.
3. Disconnect harness connectors and fuel pipe fix bolt.
Connector: speed sensor.
4. Removing the speedometer driven gear bushing and
driven gear, drain extension housing assembly fluid.
5. Remove propeller shaft (1) and mass (2).
NOTE: Apply alignment marks on the flange at both front
and rear sides.
6. Remove extension housing assembly (3) from the
vehicle.
Installation
1. Apply a thin coat of molybdenum disulfide grease to
the extension shaft spline as shown in the figure.
260RY00004
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст