Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 404
7A–29
AUTOMATIC TRANSMISSION (4L30–E)
10. Remove selector lever subassembly.
256R200005
Installation
1. Install selector lever subassembly.
2. Connect harness connector.
3. Connect shift lock cable.
D
Refer to
Shift Lock Cable in this section.
4. Connect select cable.
D
Refer to
Select Cable in this section.
5. Install selector lever knob and cover assembly.
6. Install front console.
7. Install rear console.
8. Install center cluster assembly, cluster upper cover
and knee pads.
9. Connect negative (–) battery cable.
10. After installation, make sure that the selector lever
operates normally, and that each selector position is
properly indicated. (The red mark shows through the
window.)
Select Cable
Removal
1. Set selector lever in “P” position.
2. Remove knee pads, cluster upper cover, center
cluster assembly, rear console, front console,
selector lever knob and cover assembly.
D
Refer to
Selector Lever in this section.
3. Disconnect inner cable by pulling projection on pin.
256R200006
7A–30
AUTOMATIC TRANSMISSION (4L30–E)
4. Press down claws and disconnect cable assembly.
A07RW017
5. Remove nuts that fasten grommet in select cable
assembly.
6. Disconnect inner cable.
210RW013
7A–31
AUTOMATIC TRANSMISSION (4L30–E)
7. Slide sleeve and disconnect cable assembly.
A07RW082
8. Pull lock.
A07RW015
9. Draw select cable assembly into the interior side.
7A–32
AUTOMATIC TRANSMISSION (4L30–E)
Installation
1. Set selector lever in “P” position.
2. Let out select cable transmission side end from floor
hole.
3. Fit outer cable into bracket in selector lever assembly.
A07RW016
4. Set inner cable end in selector lever and push pin into
selector lever hole and inner cable end.
256R200007
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст