Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1550
7A–40
AUTOMATIC TRANSMISSION (4L30–E)
(HEC Model)
240R100007
Legend
(1) Transmission Oil Cooler Pipe
(2) Select Cable
(3) Rear Propeller Shaft
(4) Rear Mount Rubber and Propeller Protector
Assembly
(5) Fuel Pipe Heat Protector
(6) Third Crossmember
(7) Under Cover
(8) Torque Converter Bolt
(9) Rear Mount Nut
(10) Engine-Transmission Bolt
(11) Harness Connector
(12) Transmission Assembly
7A–41
AUTOMATIC TRANSMISSION (4L30–E)
Removal
NOTE: Before removing transmission and transfer
assembly from vehicle, change the transfer mode to 2WD
using push button on dash panel (V6, 4
×
4).
1. Disconnect battery ground cable.
2. Remove transfer protector (4
×
4) and fairing plate
(V6).
150RW006
3. Remove rear propeller shaft and front propeller shaft
(4
×
4).
NOTE: Apply alignment marks on the flange at both front
and rear sides.
401RW008
401RW007
4. Remove center exhaust pipe (V6, 4
×
4).
150RW008
7A–42
AUTOMATIC TRANSMISSION (4L30–E)
5. Remove fuel pipe heat protector and clip.
6. Disconnect fuel pipe bracket from third crossmember.
141RW004
7. Disconnect fuel pipe bracket from transmission side.
(V6, 4
×
4)
141R100004
(V6, 4
×
4)
240RW014
(V6, 4
×
2)
141RW006
7A–43
AUTOMATIC TRANSMISSION (4L30–E)
(HEC)
253R100002
(HEC)
141R100003
Fuel hose connector removal procedure
If removal of the fuel hose connector is required for
transmission servicing and/or replacement, follow the
steps below.
141RY00007
NOTE:
D
An O-ring is used as a seal between the fuel pipe and
the connector. Take care not to damage the contact
surfaces during the removal procedure. Do not allow
the surface to become contaminated with dirt or other
foreign material.
D
Perform the entire removal procedure with your
hands. Do not use tools.
1. Separating the connector and fuel pipe
1. Clean the fuel pipe and connector to remove
mud and other dirt.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст