Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 1644
8F–18
BODY STRUCTURE
Installation
To install, follow the removal steps in the reverse order
noting the following points:
1. Set the position of installing the engine hood lock
assembly(4).
• Install the buffers (3) to the body.
• Adjust the buffers as the position of the engine
hood (1) is 2mm (0.08in) to the fender panel (2).
2. Fix the engine hood lock assembly.
• Tighten the hood lock assembly fixing bolts under
condition 1 to the specified torque.
Torque : 10 N·m (87 lb in)
610R200014
3. Adjust the appearance quality. (Engine hood and
fender panel)
• By buffers, adjust the difference of the height of
engine hood is 0
±0.5mm (0±0.02in) to the fender.
(Turn the buffers approx. one revolution and
move the position of buffers upward.)
610R200015
4. Reroute the control cable to its original position, and
check and see if the lock assembly and control lever
work normally.
BODY STRUCTURE
8F–19
Radiator Grille
Parts Location
603RY00004
EndOFCallout
Removal
1. Open the hood.
2. Support the hood.
3. Remove radiator grille.
• Raise the clips on the radiator grille and remove
screw.
603RY00011
4. Pull out the radiator grille rubber from fender panel
front lower side.
Legend
(1) Radiator Grille Rubber
(2) Screw
(3) Radiator Grille Assembly (LWB)
(4) Clip
(5) Radiator Grille Assembly (SWB)
8F–20
BODY STRUCTURE
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the radiator grille clips remaining on the body
side in the radiator grille, and then install the radiator
grille on the body.
BODY STRUCTURE
8F–21
Front Fender Panel
Parts Location
605RY00002
EndOFCallout
Removal
1. Disconnect the battery ground cable.
2. Remove the radiator grille assembly.
• Refer to Radiator Grille in this section.
Legend
(1) Antenna Assembly
(2) Front Fender Panel
(3) Front Turn Signal Light Assembly
(4) Radiator Grille
(5) Inner Liner
(6) Front Mud Flap
(7) Front Wheel Arch Moulding (if so equipped)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст