Isuzu Trooper (1998-2002 year). Manual — part 221
5C – 36 POWER ASSISTED BRAKE SYSTEM
STOPLIGHT SWITCH REPLACEMENT
6
7
5
4
2
3
M/T
1
Removal Steps
1.
Shift Knob
2.
Front Console Assembly
3.
Lower Cluster Assembly
4.
Instrument Panel Driver Lower Cover
Assembly
5.
Stoplight Switch Connector
6.
Lock Nut
7.
Switch
Installation Steps
7.
Switch
6.
Lock Nut
5.
Stoplight Switch Connector
4.
Instrument Panel Driver Lower Cover
Assembly
3.
Lower Cluster Assembly
2.
Front Console Assembly
1.
Shift Knob
REMOVAL
1. Shift Knob
2. Front Console Assembly
3. Lower Cluster Assembly
4. Instrument Panel Driver Lower Cover Assembly
5. Stoplight Switch Connector
6. Lock Nut
7. Switch
This illustration is based on the LHD model.
POWER ASSISTED BRAKE SYSTEM 5C – 37
INSTALLATION
7. Switch
•
Adjust the stoplight switch to the specified
clearance (between switch housing and brake
pedal) by rotating the switch housing.
Clearance
mm (in)
0 – 0.2 (0 – 0.008)
NOTE:
While adjusting the installation of the stoplight
switch, make sure that the threaded part of the
stoplight switch does not push the brake pedal.
6. Lock Nut
5. Stoplight Switch Connector
4. Instrument Panel Driver Lower Cover Assembly
3. Lower Cluster Assembly
2. Front Console Assembly
1. Shift Knob
(A)
5C – 38 POWER ASSISTED BRAKE SYSTEM
FLUID RESERVOIR TANK
2
4
1
3
Removal Steps
1.
Electrical connector
2.
Retainer
3.
Fluid reservoir
4.
O-ring
Installation Steps
To install, follow the removal steps in the
reverse order.
REMOVAL
NOTE:
Before removing fluid reservoir, remove brake fluid
from fluid reservoir.
1. Electrical Connector
2. Retainer
3. Fluid Reservoir
•
The fluid level sensor is built into the fluid
reservoir. It cannot be removed for servicing.
4. O-ring
INSTALLATION
To install, follow the removal steps in the reverse
order, noting the following points;
4. O-ring
•
O-ring must be set onto the fluid reservoir, before
installing fluid reservoir.
Retainer
Fluid reservoir
O-ring
POWER ASSISTED BRAKE SYSTEM 5C – 39
MASATER CYLINDER ASSEMBLY
6
2
1
5
3
4a
4b
Removal Steps
1.
Electrical connector
2.
Brake pipes
3.
2 attaching nuts
4a. P&B valve and bracket
4b. 3-way connector and bracket (Vehicle
with LSPV only)
5.
Master cylinder
6.
Spacer and 2 gaskets
Installation Steps
To install, follow the removal steps in the
reverse order.
This illustration is based on the LHD model.
330RW015
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст