Isuzu Trooper (1998-2002 year). Manual — part 1022
8F–16
BODY STRUCTURE
Engine Hood Hinge
Parts Location
610RW012
Legend
(1) Hinge Fixing Bolts And Nuts
(2) Hood End Seal
(3) Engine Hood Hinge
(4) Engine Hood
(5) Cowl Cover
Removal
1. Remove cowl cover.
D
Refer to Cowl Cover in this section.
2. Remove engine hood.
D
Refer to Engine Hood in this section.
3. Remove hinge fixing bolt and nut.
4. Remove engine hood hinge.
5. Remove hood end seal.
Installation
To install, follow the removal steps in reverse order noting
the following points:
1. Tighten the hood hinge fixing bolt and nut to the
specified torque.
Torque 13 N
•
m (1.3kg·m/113 lb in)
8F–17
BODY STRUCTURE
Engine Hood Lock
Parts Location
610RW011
Legend
(1) Hood Lock Control Lever
(2) Control Cable
(3) Engine Hood Lock Assembly
(4) Radiator Grille
(5) Inner Liner
Removal
1. Remove hood lock control lever.
2. Remove inner liner.
3. Remove control cable.
D
Remove the cable fixing clips from the body panel.
4. Remove radiator grille.
D
Refer to Radiator Grille And Front End Lower Panel
in this section.
5. Remove engine hood lock assembly.
D
Apply setting marks (1) to the hood lock assembly
and the body prior to removal.
610RW009
8F–18
BODY STRUCTURE
Installation
To install, follow the removal steps in reverse order noting
the following points:
1. Reroute the control cable to its original position, and
check and see if the lock assembly and control lever
work normally.
2. Tighten the hood lock assembly fixing bolts to the
specified torque.
Torque : 10 N
•
m (1.0kg·m/87 lb in)
Radiator Grille And Front End Lower Panel
Parts Location
603RY00002
Legend
(1) Front End Lower Panel
(2) Head Light Wiper
(3) Radiator Grille
(4) For ISUZU Brand Vehicle Only
Removal
1. Open the hood.
2. Support the hood.
3. Remove headlight wiper.
D
Refer to Headlight Wiper Arm & Blade in
Wiper/Washer System section.
8F–19
BODY STRUCTURE
4. Remove radiator grille.
D
Raise the clips (1) on the radiator grille and remove
two screws.
603RW012
5. Remove front end lower panel.
D
Remove two fixing bolts and remove the panel from
the fender.
Installation
To install, follow the removal steps in reverse order, noting
the following point.
1. Install the radiator grille clips remaining on the body
side in the radiator grille, and then install the radiator
grille on the body.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст