Nissan Almera Tino V10. Manual — part 232
ATC-124
VENTILATION AIR FILTER
VENTILATION AIR FILTER
PFP:27277
Removal and Installation
EJS00317
FUNCTION
Air inside passenger compartment is kept clean at either recircula-
tion or fresh mode by installing ventilation air filter into blower unit.
REPLACEMENT TIMING
Refer to MA-5 (Except for Europe), MA-8 or MA-11 (For Europe), “CHASSIS AND BODY MAINTENANCE”.
Caution label is fixed inside the glove box.
REPLACEMENT AND PROCEDURES
1.
Remove the glove box.
2.
Remove the ventilation air filter cover.
3.
Take out the ventilation air filter from blower unit.
4.
Replace with new one and reinstall on blower unit.
5.
Reinstall the glove box.
RHA680H
RHA681H
HEATER CORE
ATC-125
C
D
E
F
G
H
I
K
L
M
A
B
ATC
HEATER CORE
PFP:27140
Removal and Installation
EJS00318
1.
Remove the heater & cooling unit. Refer to
ATC-118, "Removal and Installation"
.
2.
Separate the heater & cooling unit, then remove the heater core. Refer to
.
ATC-126
DUCTS AND GRILLES
DUCTS AND GRILLES
PFP:27860
Removal and Installation
EJS00319
VENTILATOR DUCT, DEFROSTER NOZZLE AND DEFROSTER DUCTS
NOTE:
This illustration is for RHD models. The layout for LHD models is symmetrically opposite.
CENTER VENTILATOR GRILLE
1.
Remove the cluster lid C. Refer to BT-22, "INSTRUMENT PANEL ASSEMBLY".
2.
Remove the center ventilator grille assembly.
1.
Side defroster duct (right)
2.
Side defroster duct (center)
3.
Side defroster duct (left)
4.
Defroster nozzle
5.
Ventilator duct
6.
Instrument panel
7.
Side ventilator grille (left)
8.
Instrument finisher A
9.
Cluster lid C
10
.
Instrument finisher B
11
.
Side ventilator grille (right)
12
.
Center ventilator grille assembly
RJIA2335E
RJIA2336E
DUCTS AND GRILLES
ATC-127
C
D
E
F
G
H
I
K
L
M
A
B
ATC
SIDE VENTILATOR GRILLE
1.
Remove instrument finisher B.
2.
Remove the side ventilator grille (right).
3.
Remove instrument finisher A.
4.
Remove side ventilator grille (left).
FOOT DUCT
1.
Remove the heater & cooling unit. Refer to
.
2.
Remove the foot duct.
FLOOR DUCT
1.
Remove instrument lower center panel. Refer to BT-22, “INSTRUMENT PANEL ASSEMBLY”.
2.
Remove center floor duct.
3.
Remove the front seats.
4.
Peel back the floor trim to a point where the floor duct is visible.
5.
Remove floor ducts.
RJIA2337E
RJIA2338E
RJIA0830E
RJIA2339E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст