Nissan Almera Tino V10. Manual — part 190
AT-484
[ALL]
REPAIR FOR COMPONENT PARTS
7.
Press out reduction pinion gear bearing from reduction pinion
gear.
8.
Remove reduction pinion gear bearing outer race from transmis-
sion case.
INSPECTION
Output Shaft, Idler Gear and Reduction Pinion Gear
●
Check shafts for cracks, wear or bending.
●
Check gears for wear, chips and cracks.
Bearing
●
Make sure bearings roll freely and are free from noise, cracks,
pitting or wear.
●
When replacing taper roller bearing, replace outer and inner
race as a set.
Seal Ring Clearance
●
Install new seal rings to output shaft.
●
Measure clearance between seal ring and ring groove of output
shaft.
●
If not within allowable limit, replace output shaft.
●
Install new seal rings to bearing retainer.
●
Measure clearance between seal ring and ring groove of bearing retainer.
AAT538
SAT651D
SPD715
Standard clearance:
0.10 - 0.25 mm (0.0039 - 0.0098 in)
Allowable limit:
0.25 mm (0.0098 in)
Standard clearance:
0.10 - 0.25 mm (0.0039 - 0.0098 in)
SAT652D
REPAIR FOR COMPONENT PARTS
AT-485
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
●
If not within allowable limit, replace bearing retainer.
ASSEMBLY
1.
Press reduction pinion gear bearing on reduction pinion gear.
2.
Install reduction pinion gear bearing outer race on transmission
case.
3.
Press idler gear bearing inner race on idler gear.
4.
Install idler gear bearing outer race on transmission case.
Allowable limit:
0.25 mm (0.0098 in)
AAT688
SAT654D
AAT689
SAT901D
AT-486
[ALL]
REPAIR FOR COMPONENT PARTS
5.
Press output shaft bearing on output shaft.
6.
Press needle bearing on bearing retainer.
7.
Install snap ring to bearing retainer.
8.
After packing ring grooves with petroleum jelly, carefully install
new seal rings on output shaft and bearing retainer.
●
Roll paper around seal rings to prevent seal rings from
spreading.
SAT939D
SAT658D
SAT659D
SAT660D
SAT661D
REPAIR FOR COMPONENT PARTS
AT-487
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Band Servo Piston Assembly
ECS009CS
COMPONENT
DISASSEMBLY
1.
Remove band servo piston snap ring.
2.
Apply compressed air to oil hole in transmission case to remove
OD servo piston retainer and band servo piston assembly.
●
Hold band servo piston assembly with a rag or nylon
waste.
3.
Apply compressed air to oil hole in OD servo piston retainer to
remove O/D servo piston from retainer.
●
Hold OD band servo piston while applying compressed
air.
SAT098K
SAT288D
SAT289D
SAT290DB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст