Nissan Almera Tino V10. Manual — part 147
AT-312
[EXC.F/EURO-OBD]
TROUBLE DIAGNOSES FOR SYMPTOMS
1. O/D OFF Indicator Lamp Does Not Come On
ECS009A7
SYMPTOM:
O/D OFF indicator lamp does not come on for about 2 seconds when turning ignition switch to “ON”.
1.
CHECK TCM POWER SOURCE
1.
Turn ignition switch to “ON” position.
(Do not start engine.)
2.
Check voltage between TCM terminals 10, 19, 28 and ground.
3.
Turn ignition switch to “OFF” position.
4.
Check voltage between TCM terminal 28 and ground.
OK or NG
OK
>> GO TO 2
NG
>> Check the following items:
●
Harness for short or open between ignition switch and
TCM terminals 10, 19 and 28 (Main harness).
●
Refer to
AT-344, "Wiring Diagram — AT — MAIN"
.
●
Ignition switch and fuse. Refer to EL-11, “Power Supply Routing”.
2.
CHECK TCM GROUND CIRCUIT
1.
Turn ignition switch to “OFF” position.
2.
Disconnect TCM harness connector.
3.
Check continuity between TCM terminals 25, 48 and ground.
If OK, check harness for short to ground and short to power.
OK or NG
OK
>> GO TO 3
NG
>> Repair open circuit or short to ground or short to power
in harness or connectors. Refer to
.
3.
CHECK LAMP CIRCUIT
1.
Turn ignition switch to “OFF” position.
2.
Check resistance between TCM terminals 13 and 10, 19.
3.
Reinstall any part removed.
OK or NG
OK
>> GO TO 4
NG
>> Check the following items:
●
O/D OFF indicator lamp.
Refer to EL-102, ”Combination Meter”.
●
Harness and fuse for short or open between ignition
switch and O/D OFF indicator lamp (Main harness)
Refer to EL-11, “Power Supply Routing”.
●
Harness for short or open between O/D OFF indicator lamp and TCM.
Voltage:
Battery voltage
Voltage:
Battery voltage
SCIA0713E
Continuity should exist.
SCIA0766E
Resistance:
50 - 100
Ω
SCIA0767E
TROUBLE DIAGNOSES FOR SYMPTOMS
AT-313
[EXC.F/EURO-OBD]
D
E
F
G
H
I
J
K
L
M
A
B
AT
4.
CHECK SYMPTOM
Check again.
OK or NG
OK
>> INSPECTION END
NG
>> 1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
2. Engine Cannot Be Started In “P” and “N” Position
ECS009A8
SYMPTOM:
●
Engine cannot be started with selector lever in “P” or “N” position.
●
Engine can be started with selector lever in “D”, “2”, “1” or “R” position.
1.
CHECK PNP SWITCH CIRCUIT
With CONSULT-II
Does “TCM INPUT SIGNALS” in “DATA MONITOR” show damage to PNP switch circuit?
Without CONSULT-II
Does self-diagnosis show damage to PNP switch circuit?
Yes or No
Yes
>> Check PNP switch circuit. Refer to
.
No
>> GO TO 2
2.
CHECK PNP SWITCH INSPECTION
Check for short or open of PNP switch harness connector terminals 1 and 2.
Refer to
AT-337, "21. TCM Self-diagnosis Does Not Activate (PNP &
Overdrive Control Switches, and Throttle Position Sensor Circuit
Checks)"
.
OK or NG
OK
>> GO TO 3
NG
>> Repair or replace PNP switch.
3.
CHECK STARTING SYSTEM
Check starting system. Refer to SC-13, “Starting System”.
OK or NG
OK
>> INSPECTION END
NG
>> Repair or replace damaged parts.
3. In “P” Position, Vehicle Moves Forward Or Backward When Pushed
ECS009A9
SYMPTOM:
Vehicle moves when it is pushed forward or backward with selector lever in “P” position.
SCIA0706E
MCIA0102E
AT-314
[EXC.F/EURO-OBD]
TROUBLE DIAGNOSES FOR SYMPTOMS
1.
CHECK PARKING COMPONENTS
Check parking components. Refer to
Gear, Reduction Pinion Gear and Bearing Retainer"
.
OK or NG
OK
>> INSPECTION END
NG
>> Repair or replace damaged parts.
SAT282F
TROUBLE DIAGNOSES FOR SYMPTOMS
AT-315
[EXC.F/EURO-OBD]
D
E
F
G
H
I
J
K
L
M
A
B
AT
4. In “N” Position, Vehicle Moves
ECS009AA
SYMPTOM:
Vehicle moves forward or backward when selecting “N” position.
1.
CHECK PNP SWITCH CIRCUIT
With CONSULT-II
Does “TCM INPUT SIGNALS” in “DATA MONITOR” show damage to PNP switch circuit?
Without CONSULT-II
Does self-diagnosis show damage to PNP switch circuit?
Yes or No
Yes
>> Check PNP switch circuit. Refer to
.
No
>> GO TO 2
2.
CHECK CONTROL CABLE
Check control cable. Refer to
AT-412, "Control Cable Adjustment"
.
OK or NG
OK
>> GO TO 3
NG
>> Adjust control cable. Refer to
.
3.
CHECK A/T FLUID LEVEL
Check A/T fluid level again.
OK or NG
OK
>> GO TO 4
NG
>> Refill ATF.
SCIA0706E
SAT023JB
SAT638A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст