Nissan Almera Tino V10. Manual — part 112
AT-172
[EURO-OBD]
DTC P0745 LINE PRESSURE SOLENOID VALVE
DROPPING RESISTOR
●
Check resistance between two terminals.
Resistance: 10 - 15
Ω
MCIA0090E
DTC P0750 SHIFT SOLENOID VALVE A
AT-173
[EURO-OBD]
D
E
F
G
H
I
J
K
L
M
A
B
AT
DTC P0750 SHIFT SOLENOID VALVE A
PFP:31940
Description
ECS0098D
Shift solenoid valves A and B are turned “ON” or “OFF” by the TCM
in response to signals sent from the PNP switch, vehicle speed and
throttle position sensors. Gears will then be shifted to the optimum
position.
TCM TERMINALS AND REFERENCE VALUE
Remarks: Specification data are reference values.
ON BOARD DIAGNOSIS LOGIC
SCIA0718E
Gear position
1
2
3
4
Shift solenoid valve A
ON (Closed)
OFF (Open)
OFF (Open)
ON (Closed)
Shift solenoid valve B
ON (Closed)
ON (Closed)
OFF (Open)
OFF (Open)
Termi-
nal No.
Wire color
Item
Condition
Judgement stan-
dard
(Approx.)
11
L/W
Shift solenoid
valve A
When shift solenoid valve A oper-
ates.
(When driving in “D
1
” or “D
4
”.)
Battery voltage
When shift solenoid valve A does not
operate.
(When driving in “D
2
” or “D
3
”.)
0V
Diagnostic trouble code
Malfunction is detected when...
Check items (Possible cause)
: SFT SOL A/CIRC
TCM detects an improper voltage drop
when it tries to operate the solenoid valve.
●
Harness or connectors
(The solenoid circuit is open or shorted.)
●
Shift solenoid valve A
: P0750
AT-174
[EURO-OBD]
DTC P0750 SHIFT SOLENOID VALVE A
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE” has been previously conducted,
always turn ignition switch “OFF” and wait at least 5 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
With CONSULT-II
1.
Turn ignition switch “ON” and select “DATA MONITOR” mode for
“ENGINE” with CONSULT-II.
2.
Start engine.
3.
Drive vehicle in D position and allow the transmission to shift “1”
→
“2” (“GEAR”).
4.
If DTC is detected, go to
AT-176, "Diagnostic Procedure"
.
With GST
Follow the procedure “With CONSULT-II”.
SAT014K
SAT020K
DTC P0750 SHIFT SOLENOID VALVE A
AT-175
[EURO-OBD]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Wiring Diagram — AT — SSV/A
ECS0098E
YAT379A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст