Nissan Murano Z51. Manual — part 942
INT-38
< REMOVAL AND INSTALLATION >
BACK DOOR TRIM
BACK DOOR TRIM
Exploded View
INFOID:0000000005513301
Removal and Installation
INFOID:0000000005513302
REMOVAL
BACK DOOR FINISHER INNER
1.
Fully open back door.
2.
Disengage pull handle finisher (1) fixing pawls with remover tool
(A) and then remove pull handle finisher.
1.
Auto power back door switch finisher 2.
Back door finisher inner
3.
Pull handle finisher
4.
Back door finisher lid
5.
Back door assembly
6.
Back door plate
7.
Back door hinge cover
: Clip
: Pawl
: Metal clip
JMJIA1382ZZ
: Pawl
JMJIA0621ZZ
BACK DOOR TRIM
INT-39
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
3.
Push the clip center with a wrapped flat-blade screwdriver (B)
and then remove clip (A).
4.
Disengage the luggage room lamp fixing pawls with a tool, dis-
connect the harness connector (A) then remove the lamp (1)
(LH/RH)
5.
Disengage the back door finisher lid (1) fixing pawls, then
remove the back door finisher lid with remover tool (A).
6.
Remove the auto power back door switch finisher (1) by using a
remover tool (A) and then remove auto power door switch fin-
isher.
7.
Remove the back door finisher inner.
NOTE:
It is strongly recommended to follow the steps below when removing the back door finisher. Failing doing
so may cause the damage of the clips.
JMJIA1018ZZ
JMJIA1385ZZ
: Pawl
JMJIA1384ZZ
: Pawl
JMJIA1383ZZ
INT-40
< REMOVAL AND INSTALLATION >
BACK DOOR TRIM
1.
Insert remover tool (A) between back door finisher inner (1)
and back door panel to disengage the metal clips (LH/RH).
2.
Insert remover tool (A) between back door finisher inner (1)
and back window glass, pull downwards to disengage clips
as shown in the figure.
3.
Insert remover tool (A) between back door lower finisher
inner (1) and back door panel to disengage the clips.
NOTE:
Starting from the lower downwards and works around the
edges and up to the sides.
8.
Pull out to remove back door finisher inner.
9.
Disengage back door plate (1) fixing pawls and metal clips with
remover tool (A) and then remove back door plate.
: Metal clip
JMJIA1673ZZ
: Clip
: Metal clip
JMJIA1674ZZ
: Clip
JMJIA0622ZZ
: Pawl
: Metal clip
JMJIA1691ZZ
BACK DOOR TRIM
INT-41
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
10. Disengage back door hinge cover (1) fixing clips with remover
tool (A) and then remove back door hinge cover (LH/RH).
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When installing back door trim, check that clips are securely fitted in panel holes on body, and then
press them in.
: Clip
JMJIA1692ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст