Nissan Murano Z51. Manual — part 713
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
EXL-163
< ECU DIAGNOSIS INFORMATION >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
NOTE:
This operation status can be confirmed on the IPDM E/R “Data Monitor” that displays “BLOCK” for the item
“WIP PROT” while the wiper is stopped.
STARTER MOTOR PROTECTION FUNCTION
IPDM E/R turns OFF the starter control relay to protect the starter motor when the starter control relay remains
active for 90 seconds.
DTC Index
INFOID:0000000005681423
NOTE:
• The details of time display are as follows.
- CRNT: A malfunction is detected now.
- PAST: A malfunction was detected in the past.
• IGN counter is displayed on FFD (Freeze Frame data).
- The number is 0 when is detected now.
- The number increases like 1
→
2 ··· 38
→
39 after returning to the normal condition whenever IGN OFF
→
ON.
- The number is fixed to 39 until the self-diagnosis results are erased if it is over 39.
×
: Applicable
*
: For models without steering lock unit this DTC is not applied.
Ignition switch
Front wiper switch
Front wiper stop position signal
ON
OFF
The front wiper stop position signal (stop
position) cannot be input for 10 seconds.
ON
The front wiper auto stop signal does not
change for 10 seconds.
CONSULT display
Fail-safe
Refer to
No DTC is detected.
further testing
may be required.
—
—
U1000: CAN COMM CIRCUIT
×
B2098: IGN RELAY ON
×
B2099: IGN RELAY OFF
—
B2108: STRG LCK RELAY ON
*
—
B2109: STRG LCK RELAY OFF
*
—
B210A: STRG LCK STATE SW
*
—
B210B: START CONT RLY ON
—
B210C: START CONT RLY OFF
—
B210D: STARTER RELAY ON
—
B210E: STARTER RELAY OFF
—
B210F: INTRLCK/PNP SW ON
—
B2110: INTRLCK/PNP SW OFF
—
EXL-164
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
EXTERIOR LIGHTING SYSTEM SYMPTOMS
SYMPTOM DIAGNOSIS
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000005515088
CAUTION:
Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diag-
nosis if any DTC is detected.
Symptom
Possible cause
Inspection item
Headlamp does not
switch to the high beam.
One side
• Fuse
• Harness between IPDM E/R
and the front combination lamp
• Front combination lamp
(High beam solenoid)
• IPDM E/R
Headlamp (HI) circuit
Refer to
.
Both sides
Symptom diagnosis
"BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM"
Refer to
High beam indicator lamp is not turned ON.
(The headlamp switches to the high beam.)
Combination meter
• Combination meter
Data monitor "HI-BEAM IND"
• BCM (HEAD LAMP)
Active test "HEADLAMP"
Headlamp does not
switch to the low beam.
One side
Front combination lamp (High
beam solenoid)
—
Both sides
• Combination switch
• Harness between the combina-
tion switch and BCM
• BCM
Combination switch
Refer to
High beam request signal
• BCM
• IPDM E/R
IPDM E/R
Data monitor "HL HI REQ"
IPDM E/R
—
Headlamp is not turned
ON.
One side
• Fuse
• Xenon bulb
• Harness between IPDM E/R
and the front combination lamp
• Front combination lamp (xenon
headlamp)
• IPDM E/R
Headlamp (LO) circuit
Refer to
.
Both sides
Symptom diagnosis
"BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON"
Refer to
Headlamp is not turned
OFF.
When ignition switch is
turned ON
Ignition switch is turned
OFF.
IPDM E/R
—
Headlamp is not turned ON/OFF with the lighting
switch AUTO.
• Combination switch
• Harness between the combina-
tion switch and BCM
• BCM
Combination switch
Refer to
• Optical sensor
• Harness between the optical
sensor and BCM
• BCM
Optical sensor
Refer to
.
EXTERIOR LIGHTING SYSTEM SYMPTOMS
EXL-165
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
Front fog lamp is not
turned ON.
One side
• Front fog lamp bulb
• Harness between IPDM E/R
and the front fog lamp
• Front fog lamp
• IPDM E/R
Front fog lamp circuit
Refer to
.
Both side
Symptom diagnosis
"BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON"
Refer to
Front fog lamp is not turned ON.
Parking lamp is not turned ON.
• Parking lamp bulb
• Harness between IPDM E/R
and the parking lamp
• IPDM E/R
Parking lamp circuit
Refer to
.
Front side marker lamp is not turned ON.
• Front side marker lamp bulb
• Harness between IPDM E/R
and the front side marker lamp
• IPDM E/R
Front side marker lamp circuit
Refer to
.
Parking lamp and front side marker lamp are not
turned ON.
• Fuse
• Harness between IPDM E/R
and the front combination lamp
• IPDM E/R
Parking lamp circuit
Refer to
.
Tail lamp is not turned ON.
• Harness between IPDM E/R
and the rear combination lamp
• Rear combination lamp
Tail lamp circuit
Refer to
.
License plate lamp is not turned ON.
• License plate lamp bulb
• Harness between IPDM E/R
and the license plate lamp
• License plate lamp
License plate lamp circuit
Refer to
.
Tail lamp and license plate lamp are not turned ON.
• Fuse
• Harness between IPDM E/R
and the rear combination lamp
• IPDM E/R
License plate lamp circuit
Refer to
.
• Parking lamp, tail lamp, side marker lamp and li-
cense plate lamp are not turned ON.
• Parking lamp, tail lamp, side marker lamp and li-
cense plate lamp are not turned OFF.
(Each illumination is turned ON/OFF.)
Symptom diagnosis
"PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED
ON"
Refer to
Turn signal lamp does not
blink.
Indicator lamp is nor-
mal.
(Applicable side per-
forms the high flasher
activation.)
• Harness between BCM and
each turn signal lamp
• Turn signal lamp bulb
Turn signal lamp circuit
Refer to
.
Indicator lamp is includ-
ed
• Combination switch
• Harness between the combina-
tion switch and BCM
• BCM
Combination switch
Refer to
.
Symptom
Possible cause
Inspection item
EXL-166
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Turn signal indicator lamp
does not blink.
(Turn signal indicator
lamp is normal.)
One side
Combination meter
—
Both sides
(Always)
• Turn indicator signal
- Combination meter
- BCM
• Combination meter
• Combination meter
Data monitor "TURN IND"
• BCM (FLASHER)
Active test "FLASHER"
Both sides
(Only when activating
hazard warning lamp
with the ignition switch
OFF)
• Combination meter power sup-
ply and the ground circuit
• Combination meter
Combination meter
Power supply and the ground circuit
Refer to
.
• Hazard warning lamp does not activate.
• Hazard warning lamp continues activating.
(Turn signal is normal.)
• Hazard switch
• Harness between the hazard
switch and BCM
• BCM
Hazard switch
Refer to
.
Symptom
Possible cause
Inspection item
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст