Nissan Murano Z51. Manual — part 1232
SE-116
< REMOVAL AND INSTALLATION >
FRONT SEAT
• Remove the side air bag module harness (A) and disconnect
the seat cushion heater harness connector (B).
3.
Remove the seatback assembly.
• Remove the seatback mounting bolts (A), and then remove
the seatback assembly.
4.
Remove the seat cushion front finisher. (Power seat only)
• Remove the seat cushion front finisher mounting screws (A).
• Remove the seat cushion front finisher mounting pawl.
5.
Remove the seat cushion outer finisher outside.
a.
Power seat
• Remove the seat control switch knob and reclining switch knob and lumbar support switch.
• Remove the seat cushion outer finisher mounting screw (A),
metal clips and pawls.
• Disconnect the seat control switch, reclining switch and lum-
bar support switch harness connectors (Driver's seat only).
b.
Manual seat
JMJIA1426ZZ
JMJIA1427ZZ
: Pawl
JMJIA1428ZZ
: Metal clip
: Pawl
JMJIA1429ZZ
FRONT SEAT
SE-117
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
• Remove the pawls, and then lifter lever knob finisher (1).
(Driver's manual seat only)
• Remove the mounting screws, and remove the lifter lever (2).
(Driver's manual seat only)
• Pull out the reclining lever while holding and raising the pawl.
• Remove the mounting screws (A).
• Remove the metal clip and pawls, and then pull out seat cush-
ion outer finisher outside.
6.
Remove the seat cushion outer finisher inside (left).
• Remove the mounting screw (A).
: Pawl
JMJIA1090ZZ
: Pawl
JMJIA1091ZZ
:Metal clip
: Pawl
JMJIA1482ZZ
JMJIA1430ZZ
SE-118
< REMOVAL AND INSTALLATION >
FRONT SEAT
7.
Remove the seat slide outer cover (Driver's seat only) mounting
screws (A), and then slide to backward.
8.
Remove the mounting screw (A) and pawls, and then pull out
seat cushion inner finisher outer.
9.
Remove the mounting screw (A), and then pull out seat cushion
inner finisher inside (right).
10. Remove the mounting screws (A), and then pull out seat slide
inner cover. (Driver's seat only)
11. Remove the seat cushion trim and seat cushion pad. (Without occupant classification system control unit
model)
• Remove the seat cushion trim retainer.
• Remove the seat cushion trim and seat cushion pad from the seat cushion frame.
• Remove the hog rings, and separate the seat cushion trim and seat cushion pad.
12. Remove the seat belt buckle.
SB-9, "SEAT BELT BUCKLE : Exploded View"
13. Remove the driver seat control unit.
Assembly
Assemble in the reverse order of disassembly.
JMJIA1431ZZ
: Pawl
JMJIA1432ZZ
JMJIA1433ZZ
JMJIA1469ZZ
FRONT SEAT
SE-119
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
CAUTION:
Install the hog rings of seat cushion trim in position, and then securely connect the trim or trim cord
with the pad side wire.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст